Well after two long trips this year I've decided I need an upgrade. With the A/C out at the moment and the seats looking more like a toad stool I figured it was time to help myself out. So I have been eyeballing the PT cruiser seat switch and since the seats were 50 bucks for the pair at the local pick and pull it was a no brainer. Lucky for me a pt cruiser rolled in, or I should say was dragged in, last Wednesday so I went and pulled them on Friday...score. I had also decided if I was pulling the seats then I was going to pull the carpet and install sound deadener and some help with the heat. After a lot of looking and reading and watching youtube videos I am going with some good ole Frost King duct wrap. I am also planning on laying over the duct wrap some reflectix to add to both the insulation and noise factor. So we shall see how this turns out, tonight I got 90% of the interior stripped. I am only going to do the seating area, the doors and the rear quarters, I've got a storage platform in the back so there is no need to waste my time. I'm not sure how others have done it, but I removed the remaining carpet padding that was stuck to the jut with a simple sanding block and vacuum. I've got a little more to sand off and then I'll clean it good and then should be ready to lay the deadener. I do have a small rust hole on the drivers side floor that I'll address, probably gonna clean it out and then glass over and from underneath.