Builds SLOW 71

[wngrog]

It has a cross pin but you can get a solid rod in there. I’ve done it.

 

[scrapdaddy]

Thanks Guys, all good info. I was starting to sweat thinking about getting that shaft out.

 

[J Mack]

Calling @ J Mack

I got nothing ..

Looking at the exploded view Lifelong40Fan posted of the Harrop shoving the ol pipe through trick isn’t going to work, with that said I wouldn’t be scared to shove a pipe in there and hit it with all of my biggest hammers like wngrog said and see if something shakes loose.

 

[scrapdaddy]

Looks to be a hole in the center, maybe a 5/16 rod will work. I haven't started the tear down yet, so we'll see. I'm at that point right now where farm chores are more inviting.

 

[J Mack]

maybe a 5/16 rod will work.

Maybe if all else fails dissemble as far as you can and use a pulling grip to slip over the remaining axle to help pull it out. Online or any electric supply should have these.

 

[scrapdaddy]

Good idea, I don't even know yet if it's going to be a problem, but with my luck...

 

[RUSH55]

What about a push rope?

 

[scrapdaddy]

What about a push rope

All else fails, I'll try it.

 

[Gordobe]

Thin wall tubing approximate diameter [or larger] of axle. Fashion the end in a manor to squeeze over the axle in a griping fashion. I

Just throwing $%^& against the wall!!!

 

[bobm]

What about a push rope?

Isnt dat like a Wet Noodle

 

[scrapdaddy]

Exactly!

 

[RUSH55]

Isnt dat like a Wet Noodle

I heard someone mention it before. Sounded legit.

Maybe you could pack the housing full of bread and hit it with a punch?

Sorry, I’m not helping

 

[scrapdaddy]

I was thinking of testing my roll over angle and see if the shaft just slides out.

 

[samc2447]

I don't have Rush's magnification skills on the photos, but it looks like the axle shaft is right there inside the housing. Clean everything up and weld something onto the end and just try to pull it out.

 

[Lifelong40Fan]

That’s what I was thinking too.

 

[scrapdaddy]

Yeah, that's been my first choice, if I can't just grab it with a pliers. I'm not sure if you can weld chromoly well enough to hold anything, I'll have to it up. I need to get going on it and tear it apart, might just slip right out.

 

[scrapdaddy]

Quick update (with pictures, Bob!) Tore apart all the brake and backing plate stuff and the axle pulled right out. There is a ton of carnage, so everything will need to be replaced. Good news the axle housing is fine. I haven't taken apart the wheel and rotor to get the short end of axle out, yet. Jeri's making homemade Lasagna tonight, so I can't be late.

We talked about the inner splines at the diff. and they seem fine with plenty of contact.

Here's the snapped end...

Anyway, screw this, I'm eating.

 

[Pigeaten]

Mmmm, lasagna and a Bud!

 

[scrapdaddy]

3 Buds

 

[Gordobe]

I guess you LS motor just twisted that wheel off.

Go get your lasagna