Roll bar ala TLC Icon (1 Viewer)

[AF Road]

I've been searching high and low for a rollbar that looks like the TLC Icon ones as shown in the photo below. Is there an actual supplier of these type of rollbars?
My unit is a 1971 FJ40 by the way. I've removed the jumpseats too to be replaced with a forward facing fold and tumble seat.

Thanks guys!!

 

[SouthBostonFJ40]

Nope. You have to make your own or have one made. I went that route and then realized that I preferred safety over looks and installed a Metal Tech full cage.

 

[Pierps]

I believe they just take the hoops from two OEM cages and add the cross bars between them.

Not a very strong set up though.

 

[forestderp]

mine is just like that.

I believe it is just two stock units combined.

 

[SouthBostonFJ40]

I believe they just take the hoops from two OEM cages and add the cross bars between them.

Not a very strong set up though.

The Icon definitely doesn't use two OEM cages.

 

[Pierps]

I stand corrected.

 

[AF Road]

I guess I'll have to fabricate my own... thanks for the comments everyone.

 

[jackbrad]

Cirbo made me one a few years ago... I dont think it was two hard.

 

[FJsnoozer]

As stated above. Easy to make with two stock cages.

I would just call up metaltech who makes a factory looking cages in .120. Get them to send you two hoops, plates and some straight bar.

Are you going to run 3 pooint seat belts off of the front hoop?

 

[AF Road]

Yes just using Corbeau's 3 point retractable seat belts for my unit. Thanks for the references guys and hope it works out. Will give them a call.