- Joined
- Jun 21, 2011
- Threads
- 225
- Messages
- 20,975
- Location
- Redding, California
- Website
- trail-tailor.com
I have gotten these dialed in and they were approved for production this afternoon.
CNC milled from 6061 and will have two finish offerings. Bare and black hard anodized. They will come with new custom EPDM 70 gaskets and 316 stainless steel trim screws.
BOTH ARE NOW AVAILABLE ON THE WEBSITE:
Jason
CNC milled from 6061 and will have two finish offerings. Bare and black hard anodized. They will come with new custom EPDM 70 gaskets and 316 stainless steel trim screws.
BOTH ARE NOW AVAILABLE ON THE WEBSITE:
Reproduction Fender Vents - 60 Series
CNC Milled from 6061 aluminum Available in two finishes - bare aluminum or black anodized Ships with new custom EPDM 70 gaskets and 316 stainless steel trim screws Sold in pairs Please allow one week for shipping on bare, two weeks for anodized
trail-tailor.com
60 Series D Pillar Reproduction Vents
Toyota Land Cruiser 60 Series D Pillar Reproduction Vents CNC Milled from 6061 aluminum Available in bare aluminum or black anodized Ships with new custom EPDM 70 gaskets and 316 stainless steel trim screws
trail-tailor.com
Jason
Last edited: