I'm putting the rear axle for my disk brake swap back together. It's from a 74 FJ55. I put the small pieces - axle clips, center shaft & block that goes through the diff, cover nuts, etc. - into a tupperware. Now as I'm about done, I find this rubber o-ring in there. But I don't know where it came from ... I don't remember taking it out??
It looks like it might fit over that center shaft - can't tell for sure as the cover is already partly back on.
Can anybody tell me where this goes? Or did somebody slip it in there to **** with me!?
It looks like it might fit over that center shaft - can't tell for sure as the cover is already partly back on.
Can anybody tell me where this goes? Or did somebody slip it in there to **** with me!?