Thank you for the support. I really appreciate it. You are right but he never mentioned that he installed another top that did fit and had different measurements. If that is the case then the fault is in the manufacturing and there has been a lapse in quality control that needs to be addressed at my end. I will try the top sent back to me on out jig and see who went wrong here.I just finished reading your entire thread about this issue (see link in post #44 above by Ehsan) and it appears in the end you did not respond to Ehsan's instructions on how to play with the adjustments on the bow set to make your top fit better. It was also mentioned by another ih8mudder in your thread that the problem could have been solved by trimming the length of the rear bow supports. Finally, the sides pulled out at the windshield because you used a channel piece you built and not the replica Ehsan builds.
To be fair, I did not see evidence from your thread that Ehsan ignored the problem you were having or failed to post extra photos and instructions to fix it.
Ehsan