P3: Jacob's FZJ79, 1999, LX, Tan (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 19, 2023
Threads
4
Messages
456
Location
Riyadh, Saudi Arabia
TIME FOR A NEW DOCUMENTATION:
==========================================
  • TOYOTA LAND CRUISER, FZJ79, LHD
  • 1999, GCC, Qatari spec
  • Factory AC and Heater
  • LX spec "RPM, Split rear window"
  • Tan with original paint
  • About 180k km
    "112k miles"
  • Manual five-speed, H150
  • 1FZ-fe engine, Coil Pack
==========================================
1759473108571.webp


Last year, I attempted to sell this FZJ79 to the USA, but unfortunately, we had no luck. We were able to sell it locally so that we can move on. Then we repurchased it last spring. Then Last summer I tried again to sell it to the USA. Still, I encountered many unserious buyers, with some doubting the process, another was offering 13k for it, and numerous negative responses. Then, in September, a message appeared here from Jacob @vansfromjapan, who seemed to know what he wanted and had done enough research to assure that I am not a scammer seeking American money. Haha. The first text was sent on September 8. We exchanged texts, and Jacob proved to be a good negotiator. Then, ten days after the deal closed.

Hint: I keep telling my fellow Americans, you are buying from an Arab, you can negotiate


The truck arrived at my place, and then I had another text exchange with Jacob to understand what we should do with the 25-year-old truck. A full service was the decision.

Areas to address:
  • Front crank seal replacement: Front seal is not good, but we will check the rear one when we lower the trans
  • Transmission and transfer case: they will be on the ground this week, then a complete cleaning, new seals, and switches.
  • Front differential rebuild: This includes all the bearings and a complete gasket kit for the knuckles
  • Break refreshments: It is an old truck, but rotors and drums need machining only; we are going to replace all parts around them.
  • Cooling system refreshments: For such a truck, I always recommend installing a new radiator unit, but we will also be replacing additional components in the system.
1759475337007.webp


1759474973275.webp


1759475016103.webp


1759475030277.webp


 
Last edited:
We start unplugging all axles componints to add the new goods


1759484980744.webp

Front axle is good with no bad oil but we are going to replace it anyway.

  • Bearings:
    90368-49084
  • Strearing bearings:
    90366-20003
  • Knuckle kit:
    04434-60051
  • cylinder kit
    04479-60070
  • Seals
    90311-62001, and 90310-35010
  • Break pads
    04465-60340
  • Front main hose
    90947-02B51
  • Break short hoses
    90947-02B48


=====================

1759486491746.webp


Stearing components are receiving a good amount of lower arms bushes and end rods by the trusted 555
  • Lower arms bushes
    48061-60050
  • Control rod bushs
    48706-60070
=====================
1759485005584.webp

It is the first time I see bad spindle bearings, so we orderd new bearings and the locking bushs

  • Bearing
    90364-33011
  • locking bushs
    90381-35001
=====================
1759485073474.webp

Shafts ends are good

=====================
1759484950491.webp


The rear drums is receiving the following parts
  • Shoe kit
    04495-60070
  • cylinders
    47550-60120
  • Strut sets
    47061-60030 RH
    47062-60020 LH
  • Springs for Shoe
    90506-18031
  • Inner wires
    47616-35030
  • Rear main hose
    90947-02B52
 
Last edited:

Users who are viewing this thread

Back
Top Bottom