I have an older style gas tank without all the fuel vapor separator lines and no return line.
Does anyone know the fitting size for the pickup tube? SOR's diagrams don't show the older tank configuration and the threaded fuel hose connected. It's on the front right side corner of the tank.
I originally had mine brazed shut when I installed my 6AN fitting for my LS swap and I didn't think too much about installing two pickups in the tank. When I go downhill with 1/4 tank I'm sucking air and the motor sputters.
My preferred route would potentially be opening the stock pickup and tying into my current setup. Secondly I could install a bulkhead fitting but it makes me nervous to drill a 1" hole in a gas tank and hope it doesn't leak.
Does anyone know the fitting size for the pickup tube? SOR's diagrams don't show the older tank configuration and the threaded fuel hose connected. It's on the front right side corner of the tank.
I originally had mine brazed shut when I installed my 6AN fitting for my LS swap and I didn't think too much about installing two pickups in the tank. When I go downhill with 1/4 tank I'm sucking air and the motor sputters.
My preferred route would potentially be opening the stock pickup and tying into my current setup. Secondly I could install a bulkhead fitting but it makes me nervous to drill a 1" hole in a gas tank and hope it doesn't leak.