So I bought some 68" toyota truck sliders from marlin crawler. All .120 HREW tubing. Nice quality. Shipped to my door for $250. Came with 4 outriggers, plates, and gussets for each side. I also bought 6' of tubing to make front brackets due to the frame in the 80's tappering. The MC outriggers where short for these 2. First off if your looking for an out of the box kind of fitmit these are NOT for you. It took me a total of 15 hrs in 4 seperate times of work. Now I see why they charge almost $1k for bolt on sets. If your looking for cheaper way out and like welding and fabing then this is your kit. I also have my exhaust routed over the frame with very small magnaflow cat. I used a angle grinder with cutoff discs for all the cutting. Used about 2 lbs of flux core weld wire. 2 cans of sem rust shield satin spray paint. A sliding T-bevel is handy for the finding the angles trasfering to the piping. I did pick up both sides of truck off the ground by the outside of the slider. No movement at all. Check out some of the pics.
Last edited:
