I’m an idiot (1 Viewer)

[Slow Poke]

Short story. I have a problem with my wiper linkage. The last time they were working, they seized up, there was a loud popping noise and they haven’t worked since. So I started investigating. I removed the motor cover and set it on top of the passenger front tire because I’m an idiot. An hour later it starts to rain and I quickly jump in and drive the truck back into the garage and run the cover over…We’ll s***. So now I’m looking to either repair it or replace it. In looking around to see what’s available I notice everything looks different than the one I ran over. Does this look original?

 

[Engineer8000]

There should be a thread "What have you left on the front fender and driven off?"

 

[SteveH]

Wiper motor covers differ in size a little, around 1976-1978, so you may have to pick around to find exactly the one you need. Don't assume any from that era will just magically fit.

 

[45Dougal]

There should be a thread "What have you left on the front fender and driven off?"

My socket set really does seem like it ought to fit on there... picking up 1/4" and 3/8" drive sockets off the driveway has become an art now..

 

[jmylie]

Here is a part number:

85209-90800 COVER, WINDSHIELD WIPER MOTOR

Finding the right one, should be interesting

 

[dazerb]

That oughtta buff out. #Itsacruiser

 

[Mark Jennings]

I have done similar, only it was a gas cap at the gas station….didn't notice ‘till I got back to the house. Then back to the station to retrieve it….and found I wasn’t the ONLY one that ran it over

 

[timmyisinthewell]

You didn't say what year cruiser you have. My microfiche set for the US and Canadian market, period from 03/69 to 07/80 shows two different p/n's. The p/n shown above may be for a later model. I couldn't begin to tell what the difference there is between these covers. Good luck on your search for replacement or repair of existing piece.

 

[V8FJ4078]

Short story. I have a problem with my wiper linkage. The last time they were working, they seized up, there was a loud popping noise and they haven’t worked since. So I started investigating. I removed the motor cover and set it on top of the passenger front tire because I’m an idiot. An hour later it starts to rain and I quickly jump in and drive the truck back into the garage and run the cover over…We’ll s***. So now I’m looking to either repair it or replace it. In looking around to see what’s available I notice everything looks different than the one I ran over. Does this look original?View attachment 3855136

I haven't seen one with that Bump out the side...but maybe that has a heavy duty motor in it?

 

[sogncab]

There should be a thread "What have you left on the front fender and driven off?"

Side steps too. I've left numerous things on the passenger running board and driven off.

 

[Slow Poke]

Usually I just leave stuff on the roof. That would have caused far less damage.
Thanks for the diagram Jmylie. That’s what I’ve found when I’ve searched for a replacement. I’ll probably have to give one a try because this one is wrecked.
BTW, This is what I found when I opened up the cowling. Two of the three bushings broke when the arms popped off. Not sure if that’s in item that available

 

[65swb45]

I have both versions of the cover available used. I think I even have one in mustard. But iirc it's the earlier 75-77 version.

 

[21NDone]

I have both versions of the cover available used. I think I even have one in mistard. But iirc it's the earlier 75-77 version.

If the mustard 75-77 version is available I’ll take it. Will call Monday to check on availability.

 

[pb4ugo]

The bulge in your cover looks familiar. I have something similar, but not as refined. I figured i was the only one. I was looking forward to swapping the red cover out with an unaltered one, but it didn't fit. I swapped motors. Green cover and motor and the plug was in the way and the cover wouldn't fit. I didn't pursue it beyond that. I've been slicing and dicing a windshield frame. I'll figure it out in the future. I think it's a motor and wiring issue.

 

[Slow Poke]

I have both versions of the cover available used. I think I even have one in mistard. But iirc it's the earlier 75-77 version.

I’m interested. Selling?

 

[65swb45]

I’m interested. Selling?

www.marksoffroad.net

 

[Slow Poke]

I have both versions of the cover available used. I think I even have one in mistard. But iirc it's the earlier 75-77 version.

Do you sell parts? Do you have a linkage? I can push mine together but it wouldn’t take much strain and it’d pop out again

 

[Slow Poke]

www.marksoffroad.net

Your web site doesn’t seem to be working

 

[igotta40]

I have done similar, only it was a gas cap at the gas station….didn't notice ‘till I got back to the house. Then back to the station to retrieve it….and found I wasn’t the ONLY one that ran it over

I put my gas cap on the running board once, filled up and drove to the movies. When I went around to the passenger side it was still sitting there.

 

[bikersmurf]

Your web site doesn’t seem to be working

Yes, he sells parts, is a master carb rebuilder, and knows these trucks incredibly well. @65swb45 is old school and does business over the phone.

Try this link: Marks Off Road Home Page - https://marksoffroad.net/index2.html

I couldn't get his link to work either.

I drove to the grocery store with a can of pop on the passenger side front fender. It was 8 minutes down the road... and it was still there when I got there.