Curtice
SILVER Star
In the middle of a rebuild on my H42. Have pulled all the bearings and separate all of the gears, so ready to clean everything and inspect. To start, I have two questions.
1) FSM just says inspect for wear and damage. What are the typical wear points and anything specific I should be looking for? Picture below is of some wear my output shaft. Any thoughts on how it looks? I placed the transfer gear on it and it feels like it has slightly more play when placed in position vs a different part on the splines (if that makes sense).
2) Picture #2 and #3 below shows a small piece I just found laying in the bottom of the transmission case. Does anyone know what it is? It looks like something that fell off and maybe got chewed up? (I've never used this transmission and it hasn't been used in many years before I purchased the cruiser).
1) FSM just says inspect for wear and damage. What are the typical wear points and anything specific I should be looking for? Picture below is of some wear my output shaft. Any thoughts on how it looks? I placed the transfer gear on it and it feels like it has slightly more play when placed in position vs a different part on the splines (if that makes sense).
2) Picture #2 and #3 below shows a small piece I just found laying in the bottom of the transmission case. Does anyone know what it is? It looks like something that fell off and maybe got chewed up? (I've never used this transmission and it hasn't been used in many years before I purchased the cruiser).