I am having a leak from the fuel line pictured. Coming out of the top of the nut. Does anyone have any idea where I can get a replacement fuel line. Looked all over the internet, but haven't had any luck. Any input would be appreciated.
Fuel Line Question (2 Viewers)
- Thread starter Cloud40
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
I'd guess some PO replaced the metal fuel line with fuel hose. You can get a bard fitting or make/buy a metal tube to fix your bad one.
Have you inspected the inside of the nut/flare and the fitting - maybe its just loose or there is crud causing the leak.
Year/market/model helps point at the correct part faster.
www.sor.com
Have you inspected the inside of the nut/flare and the fitting - maybe its just loose or there is crud causing the leak.
Year/market/model helps point at the correct part faster.
FJ40, FJ45, FJ55, FJ60, FJ62, FJ80, FZJ80, UZJ100 Land Cruiser Fuel Pump - Specter Off-Road
Toyota Land Cruiser parts since 1983. From the oldest FJ25 and to the newest Land Cruiser, Non USA or domestic 40 Series, 60 Series 80 Series or 100 Series, SOR has the largest selection of top quality new and used OEM and aftermarket Land Cruiser parts in stock in the world. Specializing in...
brian
SILVER Star
Did you try to snug it up?
There is supposed to be a ferrule compression fitting under that nut. What does your look like? You can try to loosen tighten, loosent ighten, to get it so seat if the proper ferrule is in there.
- Thread starter
- #5
Yes
More likely flare in tube like oem; should tighten up, squish flare more and stop.
I run one of those cheap like $10 electric diode fuel pump - they last me about 10 years (I carry a spare) Really expensive ones last 5. Fuel pump block off plate eliminated the oil leak. Not a purest.
- Thread starter
- #8
The compression fitting is under the nut, I will take a picture of it.
brian
SILVER Star
Often reffered to as the olive.
Yes, thank you! I forgot that.
brian
SILVER Star
You could try to just shorten it a touch.
Its possible the line is broken where the olive pinched it.
- Thread starter
- #12
Do I need to cut the old olive off the line and install new one? I think spector carries the fitting and nut
Get the british standard pipe tap barbed nipple that fits pump and carb - eliminate all the extra hose clamps and fittings. Buy a section of fuel hose to go from the carb to the pump. I buy rolls of USA fuel hose off ebay 5/16 x 25' for $32 delivered
brian
SILVER Star
For now you could reuse the old .
GA Architect
SILVER Star
