- Thread starter
- #21
Yeah, pause slide and shift is not good. But harsh engagement isn’t either. The right balance between that is perfect.
On the valve body upgrade.
Now, day two fabrication. About out of the woods and clear of this ! I could have pulled the engine in the time spent doing these mods.
Heat enchanter bolted up yesterday, today was the pump mounting. In the instructions keep it low to prevent cavitation, so I elected to mount it right in front of my airbox and allow the water lines to plumb by the head light to the heat exchanger.
Required two holes being drilled in fender well , and a bracket formed.
On the valve body upgrade.
Now, day two fabrication. About out of the woods and clear of this ! I could have pulled the engine in the time spent doing these mods.
Heat enchanter bolted up yesterday, today was the pump mounting. In the instructions keep it low to prevent cavitation, so I elected to mount it right in front of my airbox and allow the water lines to plumb by the head light to the heat exchanger.
Required two holes being drilled in fender well , and a bracket formed.