Delta VS front radius arms?

[arndog123]

People that have these how are they holding up and any issues? This past weekend I was helping my parents winch out a couple small trees with the '96 LX and noticed chunks of my Ironman caster correction bushings were being pushed out. Guess I need to replace them and thought about going with caster plates but decided screw it and just ordered Delta arms with all new hardware. Depending on how I like them the '97 LC will probably get a set too.

 

[shocktower]

This is a great choice you will be happy

 

[jonheld]

Delta VS Radius Arms

@Delta VS You mentioned Heim joints earlier in this thread but I never saw them mentioned again. Would replacing the frame end bushing with a Heim joint give more flex?

forum.ih8mud.com

 

[baldilocks]

Holding up well to beatings on rocks and truly correct castor angle with enhanced off road Performance in mind.

 

[cybrstar]

I have a couple of buddies running them and they look very well made. Another Company would be Slee which are built out of billet steel but only for a 6 inch lift. Both use stock bushings.

 

[arndog123]

I’m not quite ready for a 6” lift but it has crossed my mind.

 

[dsmud4u]

Just get them, you’ll be happy. I have the versions that give me a tad more castor then OEM for my 3” lift but I’ve considered getting the 6” versions instead to make my long commutes easier.

 

[musthave]

I use DVS on every build I do now, and am extremely happy with them. They are in the beast mode category for me. Will never do another build without them.

 

[COYS]

Love them. My caster at +4. Retains stock wheelbase unlike the caster plates. Drives about as well as a 23 year old lifted truck can drive on 35s. You'll wonder why you didn't do it sooner.

 

[arndog123]

Installed a set on the LX Tuesday and just got done mounting a set on the ‘97. Both drive nice and straight with no issues. Pretty impressed with the quality of the arms.

Next mod are rear bumpers. I had planned on going with the Slee on both rigs but having second thoughts after checking out the Delta. Love how it’s modular. Decisions, decisions.....

 

[Rusty Marlin]

I went with Delta VS for the Icon 3" kit. Dave was amazingly patient with this noob and answered all my questions.
The control arms are drop in and dead simple to install.
They've been on the rig for a year now and I am very pleased with the handling.

 

[Pascoscout]

Love mine. Just beat the snot out of them on Moab rocks and other than lost paint they held up great. Can't compare to other options as I went with these right away when I put my lift on but the truck drives like it did before the lift. Highly recommended.