musthave

Only five allowed🤦‍♂️

My other carbon footprints 😂

Another legendary car Mitsubishi Lancer Evolution

American Full-Sizes are fun... This one's only on 37s, but I don't want to cut the fenders more to fit bigger tires. It'll go thru most places where it'll fit. After 26 years, it's still my go-to truck for new-to-me trails. Doors seal...

I’d look for some ideas you may not have yet over in the ‘winching’ sub-forum. Can’t recall most users there by name, but some of the T4R & Hilux/Taco bunch have a few slick installs over the worry you have as even a locking hitch pin is quick...

Is the winch off center or is your spare tire shifted to one side?

I have done a Permenantly mounted Rear Winch, Wouldnt go anywhere without it, looked at hitch options, etc, but storage of the removable and wiring meant I chose this option as am already running the front winch so the rear would take up space...

Disposed of. Sorry.

Thanks for sharing your rear cam wiring route. I have one to install and this will really help. Also, you already may be aware, but the AC/heat individual buttons are available to buy fairly cheap. I have a new OFF button ready to install...

I’ll be up north running trails. Sorry 😞

@musthave if you are free and have some time to come on down!

Ya my local dealership is sooooo bad when it comes to being on top of things and competent. Cheers

Exhausting day, block to tip!

Finally got a/c recharged to day after replacing condenser, evaporator and dryer. No leaks and 40.5 degrees!!

New kicks. FN 16x8 -25 with 315/75/r16 Yokohama Geolandar M/T Stock suspension at this time.

This week is shaping up pretty good. Curious to know if anyone has any experience with Continental Terraincontact tires.m? I picked up a set of 5 on a veterans deal. LT285//75/16 A/T E’s. I’m getting them mounted this morning and I’m anxious...

Was at the trans shop when they opened with the ole girl on the trailer Told them my theory of failure. Told them what happened when it died. The service writer goes "so it's completely cooked, isn't it?" I said you can smell it from 5...

Put in some @eimkeith lower link skids before I ruin my mounts. Some trimming was done to fit the @deltasliders in.

Also put some sewing time into my sun shades These are held in with magnets, super light and compact. Welded in some recovery points, the bolt in one's are too low for me.

Instead of the headlights with the incandescent bulbs that came with the ARB bumper, I've mounted LED headlights. To be used at day time (DRL), I've connected them to the power outlet box in the engine compartment, to the IGN connection. So after...

Nice mod. I’m about to do something similar. I ordered an LED replacement for the original from Australia and am going to swap the wire for the bumper light with the corner light. That way the corner light becomes a turn signal and the bumper...

The well-known Fusible Link of the 80 does not tolerate bending. To protect it, its connection was change - it will be permanently connected to the battery box and only the battery connection could be disconnected. To do this I purchased a copper...

Drive shafts back and installed, took it for the first test drive after motor swap. Only thing I messed up is the oil pressure sender wire!!! I had the black horseshoe clip in the tab instead of the button and think I burned up my gauge in the...