Media 200 series picture thread

[CruisersRCool]

Did you drive it around much with the roof rack and no light bar? I have the same rack but no light bar so asking for a comparison on the sound difference. Thanks.

I drove it around for about six weeks before adding the light bar. I can’t tell an appreciable difference with the sunroof open or closed.

 

[7000ft]

Hi all - long time lurker and finally posting after having gotten lots of great ideas and information from this forum over the years. Picked up a 21 MGM HE in March of this year as the family truckster and can't seem to leave it alone.

View attachment 2716932

View attachment 2716933

View attachment 2716934

Nice setup with the Rhino rack. No problem with the sharkfin antenna I assume. Could you provide me the overall height(of the flat rack from the roof line near the sharkfin antenna? Height is my concern at one of garages, Thanks in advance .

 

[kreiten]

Steel Bender...

 

[CruisersRCool]

Nice setup with the Rhino rack. No problem with the sharkfin antenna I assume. Could you provide me the overall height(of the flat rack from the roof line near the sharkfin antenna? Height is my concern at one of garages, Thanks in advance .

Sure thing. Will measure later today. But for me, it barely clears the shark fin. Didn’t need to modify anything.

 

[Tommy Dwyer]

Steel Bender...

View attachment 2717181

Always love your photos, and love your truck. That’s a right properly bashed up rear bumper there.

 

[kreiten]

Always love your photos, and love your truck. That’s a right properly bashed up rear bumper there.

thanks for the props buddy, we bought this truck for heavy use and heavy use is what it gets

 

[Killacaviar]

I guess, all that low speed bouldering is making me research tundra front end swap

I’m sourcing parts right now lol.

We’re actually moving out west at the end of the year. We take most of our trips up to southern VT wheeling. Around here I go south to the pine barrens for higher speed ripping or AOAA.

 

[CruisersRCool]

Nice setup with the Rhino rack. No problem with the sharkfin antenna I assume. Could you provide me the overall height(of the flat rack from the roof line near the sharkfin antenna? Height is my concern at one of garages, Thanks in advance .

I measured and it is about 78.5”. Say 79” to be conservative. And I have no suspension lift. I do have the OEM coil spacer on the front but measured this at the back.

 

[kreiten]

Squeezed her into a parking garage in Telluride

 

[CruisersRCool]

Squeezed her into a parking garage in Telluride

View attachment 2718061

looks tight.

 

[afgman786]

Another angle from wheeling in north cakalacky.

 

[77CJ5]

 

[77CJ5]

 

[wngrog]

This

 

[cmassa]

This

View attachment 2719340

That's a little fast for the flux capacitor. Who knows when you'll end up!

 

[wngrog]

That's a little fast for the flux capacitor. Who knows when you'll end up!

I ended up at 118 but had to set the phone down as it got squirrelly

 

[TheGrrrrr]

This

View attachment 2719340

Despite this being a photo, I swear I can see the fuel gauge moving....

 

[mdh384]

Went and did some plinking. Thank the ammo gods I stocked up when prices were still sane.

 

[eatSleepWoof]

Went and did some plinking. Thank the ammo gods I stocked up when prices were still sane.

View attachment 2720250

"WARNING: Use by other than registered owner punishable by law"

Tell us more about this highly specialized milk crate! I had no idea milk crates could even be "registered." Do you need a license to operate such milk crates? Carry insurance? haha

 

[wngrog]

BBNP