1968 fj40 resto (1 Viewer)

[JADCRUISER]

How much 90 oil needs to fill steering box???

Thanks, anyway!!

 

[JADCRUISER]

steering box done!!
I put a O-ring on the shaft case and pic the best plastic bushing near the steering wheel!!~
ready to run!!

 

[JADCRUISER]

At this time I add a mole to the colection!!
1600 fiat spider 124 !!! its fun....

 

[Nakana64]

Thanks for taking the time to detail your progress - much appreciated! Keep up the good work! Subscribed.

 

[ColoCruiserJeff]

Any updates on this, Picasso?

 

[JADCRUISER]

Still here !! Going on and of whit my 3 babys!!
This year will be
best

 

[swilson]

My mind is blown. A restoration by a model builder. Your attention to detail is fantastic!

 

[JADCRUISER]

I get the clutch master cylinder from Mark two years ago!!


This is what I get today!!!

I never think I will get the brake master cylinder twin of these one!!!
I have a couple!!! yessss!!

 

[JohnnyC]

"fraternal twins"

good to see you back... any new outside cruiser world models?

 

[JADCRUISER]

"fraternal twins"

good to see you back... any new outside cruiser world models?

I went LA for a Datsun roadster weber carbs, in Torrance.
right the next door of the TOYOTA museum
I didn't Know it was there , so good surprise!!
TOYOTA 2000, FJ 25, FJ45 wagon.....
was so cool!!!

look the brake and clutch master cylinder!!

 

[Superfj40]

you have been doing a great job, I have enjoyed reading through your thread!

 

[JADCRUISER]

Seat belts turn !
I found this seat belts on eBay
they where half rust and is messing one bucket

pull apart take me 15 minutes and all my brain!!

 

[KY Longhunter]

JADCRUISER .. ever seen this seatbelt repro website? Might save you some time

http://www.julianos.com/lift_latch_seat_belts.html

 

[JADCRUISER]

JADCRUISER .. ever seen this seatbelt repro website? Might save you some time

http://www.julianos.com/lift_latch_seat_belts.html

thanks!! they look good
I will consider them
you know , I having fun doing this!!
thanks agene
best regards

 

[JADCRUISER]

one of the dirtiest parts of the car!!
Bellhousing !!
cleaning a lot of old mud mixed whit sticky oil!!
than sand blast!

 

[JADCRUISER]

cake is ready!

 

[JohnnyC]

Mmmmm time for a little more iron in your diet

I don't think mine has ever been that clean ... Even from the factory lol

 

[JADCRUISER]

bellhousing get paint yesterday , today I fix the bottom cover and have to laminate some stone damages
hammer

 

[JADCRUISER]

some sand and ready to powder.... ... spoiled powder don't allow bondo!!

 

[JADCRUISER]

Ok just pivot bearing

to change and all parts ready