Floor pans,bodymounts floor supports rockers and rear corners.
- Thread starter bobm
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Awesome!
- Thread starter
- #463
Scuff plates
Going out today, Scrapdaddy, Tucker, NikP, and FJ55 TLC not pictured. Will P.M. track #s White plastic is protective cover for Stainless. Dont worry they are not white.
Thanks Bob.
Going out today, Scrapdaddy, Tucker, NikP, and FJ55 TLC not pictured. Will P.M. track #s White plastic is protective cover for Stainless. Dont worry they are not white.
Thanks Bob.
Wow Bob, those look great.
Those plates are going to look so good, It would be nice if I was ready to mount them.
Good Job Bob!
Good Job Bob!
- Joined
- Jun 21, 2011
- Threads
- 238
- Messages
- 22,141
- Location
- Redding, California
- Website
- trail-tailor.com
- Thread starter
- #467
Ron, in your own words you can FONDLE them they wont rust there Stainless steel. Thanks to all the Gang for the interest. Another item on the list. Ron don't forget to post your SURPRISE. MERRY CHRISTMAS.
Thanks Bob.
Thanks Bob.
I finally get to be stoked on some of your work - Scuff Plates!!!! Please keep doing what you do!
I'm in the 80 section now.....It 's good to see someone making a new and improved scuff plate....
Lou
Ordered a set today.
I'm already excited to get them installed.
JW
I'm already excited to get them installed.
JW
Got my sill plates in yesterday. The look great. I'll get pic up when I get them installed.
Speaking of: the sill plates I removed (I think they were fabricated by PO?) did not extend outboard past the weatherstripping on the bottom of the door frame. I guess I will need to cut away this weatherstripping so that the sill protector can sit inboard far enough to close the doors. Also, it wont fit over both the wiring harness and the weatherstripping on the passenger side.
Question. Did the weatherstripping end at the factory sill plate? Is the weatherstripping on the door alone enough to seal the bottom; or is there something I'm missing?
I'm planning on new door and door opening weatherstripping soon, so my install options are wide open. For those of you that have these sweet new plates; how have you been installing them?
JW
Speaking of: the sill plates I removed (I think they were fabricated by PO?) did not extend outboard past the weatherstripping on the bottom of the door frame. I guess I will need to cut away this weatherstripping so that the sill protector can sit inboard far enough to close the doors. Also, it wont fit over both the wiring harness and the weatherstripping on the passenger side.
Question. Did the weatherstripping end at the factory sill plate? Is the weatherstripping on the door alone enough to seal the bottom; or is there something I'm missing?
I'm planning on new door and door opening weatherstripping soon, so my install options are wide open. For those of you that have these sweet new plates; how have you been installing them?
JW
- Thread starter
- #475
npulver, due to the multiple bends and radii on a full rear quarter this is being temporarily shevled. But I will be offering a patch panel for the rear corners which I am running this week. Pics will follow.
Thanks Bob.
Thanks Bob.
Lol, looking for steel and havent even sealed the deal yet. That's swine flu!
Hey bob, you have some gutter sides? I recently found out mine suffers from RRGS 
https://forum.ih8mud.com/showpost.php?p=8159989&postcount=360
https://forum.ih8mud.com/showpost.php?p=8159989&postcount=360