4Runner E brake (1 Viewer)

[kdxman]

So I finally got around to getting this done,and it works.
I cut off all the bracket on the e brake except the 2 at the back end.
You will need the leave a 1/4 inch on the front top bracket or there will be clearance issues. I conected the rear bracket to the firewall as you can see in the picture finger pointing to the bolt. I routed the cable down through top the transfer case shifter rubber grommets there's 2.

 

[kdxman]

For the bottom I build my own bracket similar to the one used on the
4Runner 4 inch piece of angle iron that was attached with a longer bolt to the transfer case. Bracket attached to the angle iron is a quarter inch piece of Steel 7 inches long 1 inch wide at the short end why do the back end the holes I kind of just guess that seems to work okay pulse a little hard but it does work

 

[kdxman]

not sure why it posted the fist pictures twice but, anyway.

and go for questions

 

[swankstar]

Very nice! Thanks for posting up good pics. I see a connector/switch in there by the handle, do those hook up to our harness by any chance??

 

[kdxman]

No the connectors are different

 

[nukegoat]

Well I stand corrected. Kudos for getting this done.

 

[kdxman]

Thank you, sir.

 

[thelal]

you moved the handle (part that you pull) up higher than mine. That looks better as mine is too close to the edge
any photos of the routing of the cable that goes thru the floor and how exits

The level system you have underneath - that work ok?

any issues

 

[kdxman]

Everything works okay pulls a little hard but not bad. I don't have any pictures from underneath the vehicle of where the cable comes through but I can take one if you want

 

[thelal]

yah - pics would be good

 

[kdxman]

So here are a couple pictures for underneath where the cable comes through

 

[JaketheSSnake]

Well I stand corrected. Kudos for getting this done.

I'll pick up the torch on this one. I've had the brake assembly for 9 months now with no plans in sight. Yet! Lol

 

[LandCruiserPhil]

Nice
Does the ebrake light also work?

 

[kdxman]

Not yet, I suck at electrical

 

[thatcabledude]

Who needs a light when a rod is jabbing into your leg lol.

Nice job OP

 

[kdxman]

yeah you're definitely not going to drive off of this thing on

 

[Fj81]

What year 4runner?

 

[kdxman]

1989 1990 1991 92 93 94 95 Toyota Pickup 4Runner Parking Emergency Brake Handle

 

[kdxman]

1990-1995 OEM TOYOTA 4RUNNER PARKING BRAKE CABLE 46410-35650

 

[thelal]

So here are a couple pictures for underneath where the cable comes through

so is that coming out on thru the steering rod location?