Any front end experts on today!
For some reason I decided that the birfs needed a little fresh grease today and I pulled off the plate on top of the housing. Well i think that was a big mistake as I soon noticed the grease plug just below it and the bearing attached to the plate:whoops:.
I replaced the plate/bearing support and torqued to specs (71 pounds).
After replacing the wheel that side seems loose like the bearings are real worn or not tight enough.
What should I do now? I didn't want to tear the hud down today as we are heading out on a 800 mile trip in a few days.
What to do?
That's what I pulled off with the sticker (trunion bearing cap)!
For some reason I decided that the birfs needed a little fresh grease today and I pulled off the plate on top of the housing. Well i think that was a big mistake as I soon noticed the grease plug just below it and the bearing attached to the plate:whoops:.
I replaced the plate/bearing support and torqued to specs (71 pounds).
After replacing the wheel that side seems loose like the bearings are real worn or not tight enough.
What should I do now? I didn't want to tear the hud down today as we are heading out on a 800 mile trip in a few days.
What to do?
That's what I pulled off with the sticker (trunion bearing cap)!
Last edited: