So there is a wire in the engine bay that's a little in the way when trying to get at the oil filter from above. Easiest thing to do is disconnect it. Well the locking tab broke off when I did that. Have left it alone for years, just plugging it in and out, no problems whatsoever. But thinking of getting a new housing for it. It's a single pin connector, pretty sure it's not water proof. I'm thinking it's 90980-10165 for the female housing, can anyone confirm?
There's another wire below it that goes to the coil that I think uses the same connector, which I also just broke. Anyone else break these connectors or do you change your oil differently than I do?
There's another wire below it that goes to the coil that I think uses the same connector, which I also just broke. Anyone else break these connectors or do you change your oil differently than I do?