Great idea!
I just pulled them in my 93 and out flowed water both sides!
I have a very steep driveway and lately I’ve been backing in. The other day I noticed soaked passenger floor.
Ran trimmer line down, no obstructions, so I tried air next...
There is a very easy solution for wet floorboards: pull one of the two body screws holding the rear corner of the fender onto the body. You only need one. That will drain the pocket. If you depend on the rocker panel drains, you may be waiting...
Life is busy so when I pop into mud it isn't always over to the classifieds.
Life is also chaotic right now, uncertainties and lots of unknowns.
One of the few things that I can always depend on, is that there will be a new "toyotamatt" thread...
Many ways to skin that cat!
I’ve used welding cable but the next set I do will be with Anchor tinned marine cable. Do it once and never worry again and there will be zero voltage/current drop due to oxidized plain copper. It also has a pretty...
They're about $2 each from the dealer. Can't see the logic in looking elsewhere.
Bolt: 90105-11013
Nut: 90179-11005
Washer: 90201-11013
A full set of 4 will set you back $22.
Good idea, wonder if people would want a whole new box or just a hold down?
Doesn’t Landtank have an improved hold down?
Either is not super difficult. Composite is easier imop for a new box design.
A designed diy kit for improved OEM box is...
This sure seems like a product just waiting for development.
How about making something really useful for the 80 as opposed to cupholders, shift knobs, and other fluff?
Bought mine in 2019 and would buy it again today. 🍻
I’m able to pretty much fix most things, don’t pay people to fix it for me. I love working on it and it’s not my DD all year long, only in the summer.
Since my baseline I just put in fuel and...
Going up a thread size might create a huge headache in sourcing suitable replacement bolts.
Some bolts on these casings have minimal clearances around the head for sockets.
JIS fasteners have a smaller bolt head than the average metric bolt...
I just used Amayama and Partsouq for my 94 pickup.
Amayama took over 2 weeks. Partsouq was only a week.
All orders were well packaged.
Japan4x4 is about the same, plus Dave is a fellow Canadian.
I needed head bolts for the 3.0. Local dealer...
We have had a lot of reports about non 80 content here. I have been letting this go because it started off with a bike on an 80 and then lots of discussion on that bike and now it seems to be expanding beyond that.
Lets get back to 80's...