An absolutely awful idea.
If you’re intent on swapping, might as well go V8. 1uzfe if you must have toyota. Chevy variant otherwise.
Or if you have to have a 1fz then swap rigs.
Try a search for steering shaft seal, been discussed for over a dozen years:
Did it for you this time:
https://forum.ih8mud.com/threads/hot-drivers-feet-this-may-be-your-fix.476570/
Finished plate assembly bolted in with the new OEM firewall gasket prior to the seal being bolted in. If you look closely, you can see how well the seal is centered over the mounting bolt holes. Don't mind the FIPG mess - If you've replaced...
I got a 2.5" body lift and I think I just realized the source of the small clunk I get in the drivers floor board and gas pedal that is noticeably worse in cold weather. It is probably my steering shaft contacting the rubber. When it is hot...
Best option will be to buy connector, seal and pigtails as a kit from Balenger. Or, just buy connector, terminal and seal. They have multiple options.
They are dirt cheap and OEM quality, and the old connector housings aren't likely to survive...
@fjbj40 ,
Thanks again for your help! I would have never have come across that wire harness repair manual on my own. You saved me a lot of time and, like you said, I found the gold plated pin terminals, seals, wire loom, and a few other...
Thanks, That's really helpful.. I had some issues with crappy injector connectors from Amazon when I did my HG, that wasted so much time I swore I would only use OEM housings going forward. So many of them being sold online are crappy quality
I've been there before, and either I am overlooking it, or it has literally everything except for what I was needing.... It's a long-ass post will look over it again later tonight. Thanks
Thanks for your help, I might not have been specific tho... im seeking the little copper terminal and seal that crimps onto the wire then clips inside the 90980-11144 housing. (Without the wire attached and without the plastic housing. Was...
Hey, so I was looking into an idle issue and noticed just about every one of my wires on my MAF, TPS and IAC are in bad shape.
Does anybody know the correct terminal size / type that these housings use?
Any recommendation on mud vendors or...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.