Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
I just saw this one today near the Shell on Carmel. Probably parked in the same spot where you saw it.New to the south Charlotte neighborhood, spotted this 40 this AM. I like the stance/height on this one, curious how much lift he has. I didn't have a card with me but plan to introduce myself and come with a card next time.
View attachment 1405874
That's @jrmudder84. Common sight in the area. He used to rock a custom orange 80 kitted out the same.Saw a well build 100 yesterday on the island of 15-501 in Chapel Hill near Manning Drive as what appeared to be an emergency vehicle (at least it looked like it during a double take going by at 40mph). Custom bumpers had high visibility flashing lights. Anyone here?
Rolled into the shop with a blow head gasket
View attachment 1430006
View attachment 1430008
View attachment 1430009
View attachment 1430010
That was me. Running late for work this morning, giving it a little extra go pedal...73 south
8:30 this morning
Nice white 70 series 250 turbo diesel
Vermont Plates
Doing 85-90 mph. Impressive!
View attachment 1429920
That was me. Running late for work this morning, giving it a little extra go pedal...
No, but it it did help with airflow. When I initially drilled and tapped the exhaust manifold, I drilled a littler higher than I should have. The temp probe was hitting and resting on some metal inside of the manifold. The manifold was holding heat and the probe was not getting an accurate exhaust temp reading. I just installed a 1/8 npt male-female adapter to space the probe back. It worked. Getting much lower temps on full acceleration.Did the 4" intake help EGTs?
Fortunately a 70 Series is very aerodynamic.That was me. Running late for work this morning, giving it a little extra go pedal...
No, but it it did help with airflow. When I initially drilled and tapped the exhaust manifold, I drilled a littler higher than I should have. The temp probe was hitting and resting on some metal inside of the manifold. The manifold was holding heat and the probe was not getting an accurate exhaust temp reading. I just installed a 1/8 npt male-female adapter to space the probe back. It worked. Getting much lower temps on full acceleration.