serenity
SILVER Star
If the exchange rate didn't suck as much as the shipping costs would I'd be all over this like a rash!
Keep up the good work!
Keep up the good work!
ARCHIVE Wits' End 80 Series OEM Bumper Mounted Rear Tire Carrier (formerly AJIK)
- Thread starter NLXTACY
- Start date
-
- Tags
- 80series tire carrier wits end
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
IN. And if we're counting, US driver's side please. Thanks joey.
Count me IN too. Would be interested in right hand / passenger side configuration. Thanks!
Totally happy to see this coming back to the market, and as with all the other recent "back to the market" items (york kit, drawer kits, tailgate storage, carpet/vinyl kits), I am going to be way too cheap to spring on it. But i like seeing other guys spend their money on cool stuff. 
1973Guppie
Supporting Vendor
I hate your face Joey......
surfpig
The Anti-Tech
Dan C
Bonafide Jolly Turkaconis Freak
This is fantastic!
If only I had an 80 to put it on
If only I had an 80 to put it on
yea, mine from the last group buy came with a raw aluminum bar, I had it powdercoated to match the rest of the assembly.
if you need a pic of the aluminum license plate extender , mine is laying in the back of my cruiser, I still haven't installed my carrier yet...........
Last edited:
no problem, will grab it and take a pic as soon as I get home from work......I still have to figure out a way to light it up in its offset position, without being too crappy looking
NLXTACY... For your consideration in integrating the license plate light holder in the the tire carrier design. This would be nice if you could work it in. Thanks.
I will be watching for this solution, I don't see a patch into the current bulb holder[very small] but I was thinking of a harness I could make up that used the trailer wiring to tap into the running lights but it would be unwieldy to plug-in / un-plug every time I accessed the rear area
yea, I have had the license light bracket apart to replace a bulb, and one of my screws was broken, took me a few to repair it, I might halve to pull it again and see if I can add something that I could kinda hide that would just extend over to the new plate location
IIRC...I took the carpet off the tailgate, removed the access panel for the license plate illumination, and used that wire power the new light. I used the first thing I found which was two 3 or 4 inch led strips with 3M VHB adhesive. Put those led strips on the aluminum angle.
