Couple things happened today before getting pulled off. Disassembly time Rob posted was pretty spot on even being on your back.
What are you working on? (2 Viewers)
- Thread starter matzell
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
FamilyCamper
SILVER Star
@Toyodajunkie This is going to be a whole new beast! Looking forward to fall crawl and seeing it in action.
Got some initial progress done on the drawer and started gathering hardware and prepping the rack for the awning install.
Got some initial progress done on the drawer and started gathering hardware and prepping the rack for the awning install.
- Thread starter
- #883
Get them to tell you the ID of the tube, go to: 4130 Chrome Moly - Chromoly Tubing - https://www.stockcarsteel.com/alloy/4130-chrome-moly-tube?gad_source=1&gclid=Cj0KCQjw3vO3BhCqARIsAEWblcCdHx9GRBJWHx5ccRfm14ZRUYha6IOuqKi1fQIMnP79rj6Yua37wIEaAnYwEALw_wcB
buy it by the inch or foot and have them ship it to JDS. He will make it out of DOM for you .120 should be fine. He does not stock DOM but you can supply it for them. STS will ship directly to them. Usually about 2 days out and can only ship up to 6', I think
You may not need it for the front shaft as much as the rear shaft if you replace that one.
buy it by the inch or foot and have them ship it to JDS. He will make it out of DOM for you .120 should be fine. He does not stock DOM but you can supply it for them. STS will ship directly to them. Usually about 2 days out and can only ship up to 6', I think
You may not need it for the front shaft as much as the rear shaft if you replace that one.
davidp14
SILVER Star
With Rob’s help pressing on gears and some encouragement from Alan. Got my low range gears all squared away and installed this morning.
Last edited:
Land Shark
SILVER Star
Ohyeah man! Let the crawling begin
Land Shark
SILVER Star
To be clear “my encouragement “ was standing there with a YJ in my hand watching
- Thread starter
- #888
Test drive go ok?
Keep an eye on your speed sensor after reinstalling, mine started leaking. I had to install a new o-ring.
Mine is also leaking
Thanks for the heads up and I’ll keep an eye out on it. I replaced it a couple years ago so hoping it’s good. Didn’t really think about a new one.
FamilyCamper
SILVER Star
did some work on the drawer. Figured out mounting location and got all hardware set up. This extrusion / tnut setup is cool but lots of planning has to go into it as the tnuts have to slide in before connecting the corners. Also got light bar mounted. Need to work on wiring now.
FamilyCamper
SILVER Star
Got light bar wired and fully set !! Wired to OEM fog light switch. So bright can't wait for a night ride. Hoping to do one at fall crawl
Headlight conversion 7” round
Conventional vs led isn't different on the wiring. I don't know what wiring harness he had supplied but if there is not a relay. You will always be running brights even when you are not trying to run them as the highbeams are triggered by ground and that will feed through the lowbeams. So there...
forum.ih8mud.com
Very temped with this sale to buy the bucket and convert my 80 to round headlights. 7" round LEDs are everywhere and cheap...
80 series headlight housings only, fits with factory grille only.
ships bare metal
landcruisergrilles.com
- Thread starter
- #895
Thats a lot of cake!
You have more important things to spend money on! gears, lockers, etc.
You have more important things to spend money on! gears, lockers, etc.
Headlight conversion 7” round
Conventional vs led isn't different on the wiring. I don't know what wiring harness he had supplied but if there is not a relay. You will always be running brights even when you are not trying to run them as the highbeams are triggered by ground and that will feed through the lowbeams. So there...
Very temped with this sale to buy the bucket and convert my 80 to round headlights. 7" round LEDs are everywhere and cheap...
80 series headlight housings only, fits with factory grille only.
ships bare metal
Superbrightleds.com has high quality led bulbs that work in the factory housing and have the appropriate cutoff. I installed them in both of my previous 80’s.
FamilyCamper
SILVER Star
TC Gears out! Now to get them back in....
Ruled out the CDL button on the dash as well as the relay and motor not working in the actuator.
With the tcase in neutral, pressing the CDL button actuates the motor and it audibly is moving but spinning one of the front tires confirms the CDL doesn’t engage.
Jumping the pins for the low range switch on the tcase, same thing. You can hear it actuate but no lock.
The CDL light on the dash does come on if you jump the pins for wire to the CDL activation switch on the tcase but not otherwise. Not really sure what the issue could be.
I think to start I need to replace the three button switches tcase to rule those out since they’re all super rusty and two of them have destroyed connectors. The top one is easy, the other two not so much without the tcase tilted down…
If those don’t fix it I assume the actuator needs to come out to see what’s going on
davidp14
SILVER Star
CDL Actuator Fun
Yes, it's grey and has two plugs. I believe it is C 2 on the electical diagram, when I jump it the CDL lights and ABS lights stay on. Some have had luck with pulling that switch and exercising it, pushing the ball on the end in multiple times. It's easy to test it when it's out, the contacts...
forum.ih8mud.com
This page helped me with my CDL issues.
- Thread starter
- #900
Well, you did put it back together! lol.
No really, if the motor is making noise, then it sounds like it is working. did you spin one tire with the other on the ground?
You can pull the switch and push the ball in with it plugged in and see if it lights the light. IF so then it works. Actuator may not be pushing sleeve over enough to activate it.