Hey everyone. I am currently trying to install a 95 tbi 350 in the pig. Got all the adapters from downey and got it all put together Yesterday. I slapped the whole assembly in for mock up and ran into a few issues.
I knew it would be tight but at the moment I cannot get the stock 3 speed to line back up for the stick. I have searched the forum all morning and only seen mentions of people heating and bending the shifter to accommodate this issue. Can anyone elaborate on this and let me know if it is in fact necessary?
Right now I have a few issues but most of them I knew about, like the ram horn exhaust needed and the offset to the drivers side for driveshafts but one thing I was not aware of is the need for the shortening of the driveshaft in the front. Right now it looks to be 3 inches to long... bummer.
I have at least 7 thread open and am taking notes as I go but I'd really like to get some words of wisdom from those who have done it themselves.
One last thing... if anyone has tbi'd before I'd really love some pointers on that. I have all the schematics and took the whole harness but not sure how much I really need. When I sit down and look it over I really only need a few circuits... seems like I'll be throwing alot of the harness out.
I knew it would be tight but at the moment I cannot get the stock 3 speed to line back up for the stick. I have searched the forum all morning and only seen mentions of people heating and bending the shifter to accommodate this issue. Can anyone elaborate on this and let me know if it is in fact necessary?
Right now I have a few issues but most of them I knew about, like the ram horn exhaust needed and the offset to the drivers side for driveshafts but one thing I was not aware of is the need for the shortening of the driveshaft in the front. Right now it looks to be 3 inches to long... bummer.
I have at least 7 thread open and am taking notes as I go but I'd really like to get some words of wisdom from those who have done it themselves.
One last thing... if anyone has tbi'd before I'd really love some pointers on that. I have all the schematics and took the whole harness but not sure how much I really need. When I sit down and look it over I really only need a few circuits... seems like I'll be throwing alot of the harness out.