[quote author=anderaa13 link=board=2;threadid=4967;start=msg38040#msg38040 date=1062726506]
I've never really had much of a startup rattle, but after switching to mobil1 0w-40 I am getting a noise at startup that lasts for a few seconds and sounds very much like a knock. Oil pressure and level is fine. It happens about 4 out of 5 starts and only last for 5 seconds or so. Does this sound like the typical startup rattle or is it something to be concered about?
thanks, aaron
[/quote]
This is what my buddy was probably refering to initially..The knocking in the engine after changing oil types. Would it hurt anything to try the M1 0W 40, and if it begins to knock when starting up, then just try another like what Cruiser Dan uses, or even just go back to the 10W 30 or 10W 40??? Also, I had been going to the same place to have my oil changed and I would just supply them with a Toyota filter (not sure what model, but whatever Toyota reccomends), and he told me that there is a "high pressure" filter by Ford that works good with my Cruiser since it is a higher compression engine than ordinary. He showed me the size difference and the Ford filter had a buldge on the bottom rather than a concave such as the Toyota filter. Perhaps I had a smaller size Toyota filter, but it is what the dealer parts department gave to me. When I go back to get my filters, which one should I more specifically ask for? I am just going to start doing my own oil changes at home because I am alot more attentive to what I am doing and I don't over fill/spill oil all over my motor and axle.