32cls6speedmt
SILVER Star
Did you try cup holderSo .. does anyone know where this piece goes?
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Did you try cup holderSo .. does anyone know where this piece goes?
I wondered the same, especially after adding Escape Gear seat covers. I thought no way they could make a difference in head clearance or it was just me.....who knows.for the clydesdale class....how'd you get the drivers seat lower?
I'm 6'4" and I feel like my lid is a half inch from creasing the sunroof edge.
Anyone know of a secret way to dump the seat another inch?
I keep putting my chin into my chest to get in and out....
Worked perfectly. Thanks!I think it is M6x16mm.
Did you try cup holder
Cabin filter. If you drive past something stinky (dead skunk, cattle farm, oil refinery) you can press it and it'll remove the smell from your interior in about 30-60 seconds.While figuring out the heated wiper button location on my ‘21, I noticed another button that I don’t know the function of. It’s the one that has the seated guy with an arrow flowing through a set of perforated lines. See glamour shot.
View attachment 2785978
From a LX manual:While figuring out the heated wiper button location on my ‘21, I noticed another button that I don’t know the function of. It’s the one that has the seated guy with an arrow flowing through a set of perforated lines. See glamour shot.
View attachment 2785978
its like a HEPA filter for the air, turns off after a short while.While figuring out the heated wiper button location on my ‘21, I noticed another button that I don’t know the function of. It’s the one that has the seated guy with an arrow flowing through a set of perforated lines. See glamour shot.
View attachment 2785978
Hmm... Stick ohm meter probes in there with the ignition off and see which ones are ground. Then see if any have +12V with the ig on or off. I'm looking for convenient power too.Removed the plastic trim so I could re-secure that loose plastic ribbon thing in the truck that would smack the trunk every time I closed it and I noticed two wiring connectors that don’t go to anything. black one is on the passengers side of the trunk lid, white one inside the plastic blue cover is in the drivers side.
Anyone know what these connectors are for in the trunk of my 2013? I’m thinking the black might be for the power lift gate for the LX. No idea about the other. I’m thinking about ways to get power for some extra lighting as my trunk is far too dark at night to find stuff, especially anything in the drawer
View attachment 2786082
View attachment 2786083
And i thought i was the only one…I too have one of these, it sits on my nightstand because I don't know where the hell it came from
Unless you are in 4WD low range it doean’t matter. It is turned off.Mega SQOD here... on MY16+, what should crawl control be set at for just everyday driving (city and highway)? Mine has been always been set at the half way point and I didn't know if it should be lower and if me having it at the halfway point has affected anything. Thanks!
I flip one to a different position every few days to pretend like I saw some dirt. . .Unless you are in 4WD low range it doean’t matter. It is turned off.
I'm annoyed that I can't find a good wiring diagram for these. Wondering if they're part of the Lexus power hatch or what. Anyway I'll break out the multimeter and I'll take a look when I install my trunk lighting. I just ordered a set of these RV "puck" lights off Amazon. I have something very very similar in my trailer and they're great. My plan is to run wires up to the rear dome light (assuming I can figure out how to snake something up there) and mount these near the rear speakers in the trunk hatch. They're pretty low profile and there's a button in the center so you can opt to turn them off easily.Hmm... Stick ohm meter probes in there with the ignition off and see which ones are ground. Then see if any have +12V with the ig on or off. I'm looking for convenient power too.