Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Do a diesel swap, that stuff is safe as a pillow fight.
BMW E30’s had an optional tank that mounted in the trunk directly behind the rear seat.
TUV approved & all.
And I think those rare ‘tanker’ early 60’s racing Corvettes had similar styled tanks in them too.
No one has said a thing about ejection seats.Wow, This thread has gotten a bit off track, some of the ideas being thrown around with ejection seats and the like are just reckless.
He makes a good point though. Fighter jets don't use airbags. Clearly that means that despite the high cost, ejection seats would be the safer alternative.No one has said a thing about ejection seats.
Stop trying to derail this thought consortium!
But when do you use them?He makes a good point though. Fighter jets don't use airbags. Clearly that means that despite the high cost, ejection seats would be the safer alternative.
Complicated scenario, but I would think flares for evasion, worst case ejection, tannerite so the critical design technology doesn't fall into the wrong hands (Jeep bros?). If you hit the canopy like Goose during the ejection, then the fuel cell airbag jack for recovery?But when do you use them?
After the Angel Flares?
Before the tannerite IED evasive maneuver?
I the event of a rollover, the fuel bladders will provide cushion and could be repurposed as an airbag jack to lift the vehicle up.
The ejection seats don't work well when inverted.....
He makes a good point though. Fighter jets don't use airbags. Clearly that means that despite the high cost, ejection seats would be the safer alternative.
That’s kind of a “if you’re dumb enough to fly in one” question.Well, how come helicopters don’t have ejection seats then?
Answer me that one, smarty pants
Clearly they can‘t be ***all that safe*** -since helicopters don’t have them, and they come out of the sky harder than any winged vehicle.
Because somehow Sikorsky and Bell haven't adopted the obvious WWI technology of a synchronization gear for helicopter ejection seats, and frankly I think some design engineers should be fired.Well, how come helicopters don’t have ejection seats then?
Answer me that one, smarty pants
Clearly they can‘t be ***all that safe*** -since helicopters don’t have them, and they come out of the sky harder than any winged vehicle.
That’s kind of a “if you’re dumb enough to fly in one” question.
I think tannerite requires <2000fps impact for detonation, so you'll likely need to piss off that other driver enough that they start shooting.
Is ‘because James Bond had.....’ - a legit answer?
Put me down for 6 but made with non flammable material. How about making fire blankets with the same illustration..I have some thoughts;
First, if you utilize a manifold system, please use these instead of pvc
Crap, They're made in Korea. Sorry.HOME-FLEX 3/4 in. x 3/4 in. x (4) 1/2 in. CSST FIPT Stainless Steel Manifold 11-070504 - The Home Depot
The HOME-FLEX Manifold is a central distribution point for multiple runs of CSST. It uses standard pipe thread connections for use with valves, steel pipe or CSST male adapters. It is approved for concealedwww.homedepot.com
Also, the illustration in post #119 needs to be printed on t-shirts and a group buy must be started.
Hunh?
-You have to know how to auto-rotate to ‘drop softly’ from altitude as part of your pilot license, but c’mon - we figured out how to sync the prop blades with the machine gun on prop planes in like1930 -
We can’t figure out how to pop a man fast enough between the blades?
You had me at umbrella sleeves.All of the helicopter ejection seats I've personally seen involve some way of separating the blades prior to ejection. The Russians still use this design on the KA-50 family. From talking to pilots, the entire ejection system is often disabled by unit level mechanics. Anecdotal evidence, I know.
I have roughly 2K hours flying military R/W aircraft. Most of my time was spent at low altitude, leaving me little time to activate an ejection seat. I'm fine with sticking to the auto-rotation option. The second option is to die, I guess.
While we're on the topic of ridiculous design ideas, here is a short list of mods I plan on making to my FJ80:
-Instead of fuel bladders, I plan on making a little compartment to store an umbrella in my doors. Think Rolls Royce.
-I'm mocking up a dashboard vase, similar to the VW Beetle. I expect to start producing these in Q3 of FY20. PM me to get on the list.
-I'm almost done with my Lambo doors conversion. I've made a mental note to make the counterbalance system adjustable. I don't want to exclude those of you running fuel bladders from my potential customer base.
Finally, regarding the fuel bladders:
You should look at a system like we have in the AH-64. The design of the fuel bladder makes it resistant to projectiles up to .50 cal. If you ever brought it to market, you could advertise it as a dual use fuel/armor system. You're almost guaranteed to corner the African warlord market. Food for thought.
... You're almost guaranteed to corner the African warlord market. Food for thought.
Yes the vase idea is great but remember we need a gyro base for the vase so that when you off road the flowers and water are not soon separated.All of the helicopter ejection seats I've personally seen involve some way of separating the blades prior to ejection. The Russians still use this design on the KA-50 family. From talking to pilots, the entire ejection system is often disabled by unit level mechanics. Anecdotal evidence, I know.
I have roughly 2K hours flying military R/W aircraft. Most of my time was spent at low altitude, leaving me little time to activate an ejection seat. I'm fine with sticking to the auto-rotation option. The second option is to die, I guess.
While we're on the topic of ridiculous design ideas, here is a short list of mods I plan on making to my FJ80:
-Instead of fuel bladders, I plan on making a little compartment to store an umbrella in my doors. Think Rolls Royce.
-I'm mocking up a dashboard vase, similar to the VW Beetle. I expect to start producing these in Q3 of FY20. PM me to get on the list.
-I'm almost done with my Lambo doors conversion. I've made a mental note to make the counterbalance system adjustable. I don't want to exclude those of you running fuel bladders from my potential customer base.
Finally, regarding the fuel bladders:
You should look at a system like we have in the AH-64. The design of the fuel bladder makes it resistant to projectiles up to .50 cal. If you ever brought it to market, you could advertise it as a dual use fuel/armor system. You're almost guaranteed to corner the African warlord market. Food for thought.