Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Hi @neilsen100 and @2001LC@ghong14 I've taken the advise from others on this forum and look up part numbers specific to my vehicle (LX) and year ('99) on Partsouq.com. I highly recommend you do the same since parts can vary by year and model. I found that hose part number for my truck HERE and can be assured it fits. Partsouq is also great because you can see related parts you may want to order as well, like the hose clips.
I have no idea if this is the correct part number for your truck, but if you put in the little bit of work to lookup by your vehicle, you'll save yourself a huge potential headache and time. Hope this helps.
View attachment 2614873
Exactly what I am looking for. I guess this is what you hand the gray electric connect on.Not really a thread for asking about PN#'s,
I just now took the time too looked through pictures of first 4 or 5 pages. Found something that may help you "see" what you're looking at..
Scored 2007 Unicorn. The holy grail of 100 series.
Engine tear down and assembly. This was necessary as I'm not using a 100 series 2UZ-fe VVti drop in. Instead I scored a low mile GX470 Lexus engine from WI. To recap; it was the best engine I could find. It was in a Lexus Dealership every 5K to 6K for fluids +, was only recently salvages with...forum.ih8mud.com
The CAM senor CLAMP WIRING block housing bracket, is available. When you have a better understand, of what you're looking at. You may find! your Wire housing block, which I kind of see it in your blurry pictures. May just need block hanging on it..
View attachment 2621981View attachment 2621960
View attachment 2621975
View attachment 2621977
Good luck finding any of the harness brackets! This is 03-05.
View attachment 2622538
Did you notice the VVT cam sensor located in sides of head. RH was melted. Some plastic had to be chop out to remove bolt so I could take it out. This was necessary so I could remove the intake manifold that was being blocked by it. The RH knock sensor was also melted. Notices also the color of the cast iron of block in the valley. It had and unusual orange glow. This engine was hot!
View attachment 1678637 Knock sensor RH sideView attachment 1678638 View attachment 1678639 View attachment 1678641 View attachment 1678642
Yes. IIRC it must come off to replace wire harness, but is reused if you like.This is such an amazing thread - thank you! I assume you were able to use the intake that came with the GX engine, is that correct?
No I've not, nore look very hard. But if you've top piece even bust away, it still clips in. You can also tie down.View attachment 2623439
Looks like you were able to find the replacement for these clips! Did you come with the cover?
What size Falkens are those?Still holding with this young pup. Early 80k mi and a few California / Nevada excursions under her belt. How quickly this became the family go to vehicle I’ll never know. Besides a minor ds door panel dent( which I’ve been lazy about hot waxing) she’s been steady and regularly serviced.
View attachment 2734487
View attachment 2734488
305 65 18”What size Falkens are those?
That would be awesome! I’ll shoot you one now!You're welcome to stop by anytime, I'm So. Denver West of DTC area. Just PM me your contact info and remind me of what/why and I'll reply.