- Thread starter
- #621
rear end sprung weight 920
/
rear end unsprung weight 1650
/
rear end unsprung weight 1650
Builds rocks and rolls
- Thread starter mrqtipp
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #622
pulled out an old frame to help mock up a skid plate
cardboard templete
plasma cuts
cardboard templete
plasma cuts
- Thread starter
- #623
skid plate is flat with the frame
had to cut a small section out.
tranny sits 1/4 below frame but the rest of the drive train is well above the frame rails
had to cut a small section out.
tranny sits 1/4 below frame but the rest of the drive train is well above the frame rails
How come your To Do list is on one sheet of 8x11 paper and mine fills up a 3' x 5' dry erase board.
I must be doing something wrong.
I like that you are making progress though!
I must be doing something wrong.
I like that you are making progress though!
The fully belly skid plate is pretty awesome.
- Thread starter
- #626
Weekly lists are smaller I couldnt plan the build you did....
Thanks, it should work out pretty well.
How come your To Do list is on one sheet of 8x11 paper and mine fills up a 3' x 5' dry erase board.
I must be doing something wrong.
I like that you are making progress though!
Thanks, it should work out pretty well.
- Thread starter
- #627
trailered the rig to the driveline shop
Still working on the spring rates
.
Still working on the spring rates
.
- Thread starter
- #628
spring exchange party
- Thread starter
- #629
Bent up some exo bars for the rear quarters and front end
.
.
.
.
- Thread starter
- #630
all bars painted
- Thread starter
- #631
used a hole saw to cut holes in the body.
The body was bouncing back and I bent two drill bits when the hole saw bounced back at me.
I have broken several bits in the past but I have never bent a drill bit before
evidence of bounce back
future cut line
The body was bouncing back and I bent two drill bits when the hole saw bounced back at me.
I have broken several bits in the past but I have never bent a drill bit before
evidence of bounce back
future cut line
- Thread starter
- #632
hole cut in the rear quarter
front
.
front
.
- Thread starter
- #633
front end put together
I might tie the bars into the front bumper with a removable flange
new cut line
material cut off
I might tie the bars into the front bumper with a removable flange
new cut line
material cut off
- Thread starter
- #634
rear
tied into the frame thru the body
tied into the frame thru the body
- Thread starter
- #635
I could not get the rear left any tighter
.
- Thread starter
- #636
- Thread starter
- #637
hood tie down
hole in body
tied into hoops
hole in body
tied into hoops
- Thread starter
- #638
cleaned out storage box
- Thread starter
- #639
I need to make a new roll cage.
I made the rear section but I used the front hoops and realized that the front hoop was approx. 5 inches to the passenger side
floor relief cut
more cuts
I made the rear section but I used the front hoops and realized that the front hoop was approx. 5 inches to the passenger side
floor relief cut
more cuts
- Thread starter
- #640
relief cut
section cut out
come along
section cut out
come along
