I can't figure out why that in my first year production (JDM) 80 series they AC drier is tucked up inside high by the rad, and then in the North American markets they drop it down there for a big target.....
Oneoff custom front winch bumper fab (2 Viewers)
- Thread starter Booger weldz
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Nice shop, and bumper too.
sailor
Jackass of all trades
Simple. In Mr. T's lexicon U.S. Market 80 = Mall. Rest of world market 80= Trail.
I really dig it, very minimal!
Vehicles with the dryer up next to the battery are R12 units up until May 1993 production.
Post-May 93 R134 units move the dryer down behind the bumper, presumably to move it away from engine compartment heat.
Bumper is looking really nice; I like the lines, the minimalistic approach and the ground clearance. Are you going to cut away the sheet metal that hangs down below the wings? Let me know if he wants to make any more of them?
- Thread starter
- #28
sorry, trouble getting my iphone to work...theres more metal coming to protect further down but it still looks'low profile', no cutting factory sheetmetal, just a bit off the front/bottom corner of the frame rails...ill have some more pics shortly...
not sure the rules for advertising on this site so ill just give out the contact info for the shop and let you guys get ahold of them and respect the ih8mud management...
jeremy@binksfab.com
or
(209)402-6433
im paying about the same as i would have for a slee bumper but i got something better looking, in my opinion, and his work(bink) is very high quality(so is slees of course)...hes done work for King of the hammers Racecars if that represents his skill level, and acheivements in the industry...
not sure the rules for advertising on this site so ill just give out the contact info for the shop and let you guys get ahold of them and respect the ih8mud management...
jeremy@binksfab.com
or
(209)402-6433
im paying about the same as i would have for a slee bumper but i got something better looking, in my opinion, and his work(bink) is very high quality(so is slees of course)...hes done work for King of the hammers Racecars if that represents his skill level, and acheivements in the industry...
- Thread starter
- #29
everything hes cutting on the plasma table is saved on his harddrive so these can be reproduced multiple times for anyone with an 80...hopefully ill have nearly finished pics by the end of today for you. he is definitely willing to make more of these hes sortof a jeep guy, but i believe my landcruiser is wearing on him
im trying to make sure i respect this sites advertising rules, so contact them if you need anything or have questions, etc
Looks great so far.
- Thread starter
- #32
i dont think i posted this yet? he mocks these up outta .065 plate and then when hes happy, they get cut outta 3/16s and many of them become one piece instead of the multiple paralellograms during initial fitup
- Thread starter
- #34
Wait til u see the diffference when all that stuff becomes nearly one piece
Nice design work! Is it yours or Jeremy's? I am gonna steal it.
- Thread starter
- #36
..............
weird angle makes it look like it sticks way out?? its only 3/8'' wider than the flare...
weird angle makes it look like it sticks way out?? its only 3/8'' wider than the flare...
- Thread starter
- #37
i think its binks....hes the owner, jeremy is the sales/manager guy
Top shelf!
- Thread starter
- #39
nice and tight
that is just unreal! Awesome job. Cannot wait to see it finished.
Awesome job. Cannot wait to see it finished.
