Official 200 Series Chat and BS Thread

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Is that an onboard air system?
 
Yah, I sit right at 37 & 3/4 if you measure from the ground on the front driver and passenger sides. My rears are right under 38 on both sides (I'm using the TJM regular load rears vs. the ARB rear springs most of you use).

With that said, I do have a heavy 15K TJM winch, really heavy MetalTech sliders and a roof rack. Dunno, I never can seem to get more than about 3.5 inch lift in the front no matter how much I crank on the coilovers. I have 700 pound, 16 inch springs with about 1.5 inches of thread showing at the top.

Same here. I felt the front radflo's had settled out a bit. Cranked it up 3/8", and didn't see any change in height. It looked higher right off the jacks, but back to where it was after a test drive.
Should you back off the KDSS valves when adjusting just the front?
 
My understanding is that you should always do KDSS whenever you mess with any of the ride heights.
 
Haha i was changing my display picture and saw the number of likes received matches my number plate :D

Screenshot_2015-03-30-22-09-54.png
 
Somewhere out there, there is a fool looking to get rid of his money...
 
Local 2002 100 series for sale with only 3000 miles. 5 speed manual, black, mid spec, 1 FZ-FE.

Bidding reached $50k however the owner was still not willing to sell...I was reading the comments and a 200 owner with a 2015 5.7 wants to swap with the 02. CRAZY!!!!

I guess ill park my 200 for the next 10 years then trade in at no cost with a brand new 300 series twin turbo hybrid electroautonomous flying machine.
 
Seems like a fair price with what he's got into it. I'd buy it before a new LC if I had $70k to throw at a vehicle (provided all mods conformed to my scrutiny). With that being said, I do think part of the fun with these rigs is really "owning" them and choosing/installing your own mods. But......like I said, I don't have $70k


Sent from my extremely unreliable mobile device using IH8MUD Forum
 
And with that..just got an updated delivery ETA on the TJM: June 7th now o_O

Looking for alternatives. I've asked Proline if they can build their Rallye style for a 200, similar to this:


PD4runnerrally08_zps7904fb51.jpg

What all would you try to have them integrate if you went custom? Parking sensors, headlight nozzles?
 
What all would you try to have them integrate if you went custom? Parking sensors, headlight nozzles?

Headlight nozzles are likely. For the style I chose sensors are out. Radar cruiser control drives me crazy and the parking proximity is overly sensitive for my parking so it's no loss for me. I think I'll be happier. I'm also looking forward to less weight, exactly the functionality I want and then maybe a bit of updated style with a nod towards the past and overrider bars.

0
 
The parking sensors act all crazy when the fronts are missing. Sometimes my rears wont work. Need to get that 22mm drill bit and get mine installed soon.
 
The parking sensors act all crazy when the fronts are missing. Sometimes my rears wont work. Need to get that 22mm drill bit and get mine installed soon.

I have a good dewalt arbor/hole saw in 22mm I can post to you that is unused. PM me and I'll send it over if you don't mind sending it back once done :)
 

Users who are viewing this thread

Back
Top Bottom