Did your wife make you go get a job or something?
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
under_psi
SILVER Star
its an anomaly. i the only one working on a 40 this week. next 3 months i will still be in same spot and everyone will be done.
I worked on my pile.
MScruiser
obsessive-compulsive oppositional-defiant wise-ass
- Thread starter
- #604
I've been slammed with small engine stuff. Don't know why this particular week had so many calls, but I'm not complaining.
The 40 is being held up too; still waiting on hardware from platers and lift from Tolleson. Hardware was supposed to be ready last week; there's a chance I'll be picking it all up today though.
I did use the downtime to install some LED ballast in my shop. Good God what a difference. It was like a cave in there; now I think it looks more like an operating room. Also got the shop/tools organized.
So you got them all marked so they go back in the right spots, right.....
Boy I hope that's true.... Maybe you can make an assembly manual and sell it to me when your done cause I got the biggest jigsaw puzzle ever and there's no picture on the box to go by.
You need to borrow one to look at while doing it.
Seriously.
Seriously.
Is it sad that I know where each bolt goes? I may not know the part number like @beno but can reassemble.
MScruiser
obsessive-compulsive oppositional-defiant wise-ass
- Thread starter
- #615
You best watch what you say in front of me, unless you like frantic texts asking you tons of questions (even more than I already do...) @offr0adlim0
under_psi
SILVER Star
so nice man......
