Builds Mike’s 1D2 Daily (1 Viewer)

[Jack90210]

Been out of the loop for a while. Recently underwent a meniscus refresh, and off my feet for an extended time. Surgery went down on 20FEB, so been limited to no weight bearing on my bad knee for roughly 4 weeks. Won't have another evaluation with my surgeon for another 2 weeks, so a total of 8 weeks at a minimum on the crutches. Stacking parts here and there, mostly gonna focus on getting our 100 series on the road, prior to diving into the
old 1E3 Daily First Gen Tundra.

View attachment 3868592

View attachment 3868593

Dude! Hope you heal up quickly and fully.

 

[mcharfauros]

Dude! Hope you heal up quickly and fully.

Appreciate it brotha!

 

[mcharfauros]

25Mar25

More parts came in to add to the stack. Bearing kit via Cruiser Outfitters, along with a new power steering pump from Toyota. Not being able to work on the car kinda has me reflecting on how much time I waste, and now motivated to get this one back on the road as soon as I’m cleared to get back on both legs.

 

[mcharfauros]

Not 100 Series Stuff, but picked up a bumper from the freight house about a week ago. Came in from Clovis, California all the way to the middle of nowhere Missouri. Got the full hoop option for my 06 Tundra from Billy at Brute Force Fab.

 

[mcharfauros]

In the spirit of spring cleaning, and wanting to clear out the garage a little bit, decided to make a little room by getting these wheels and tires out of the garage. Had my son get em on the truck for me, since I still cant do much. Rock Warrior Wheels from the wife’s 200 series wrapped in 285/70/17 Falken Rubitreks. Shoutout to @Luke M for squaring me away with the 3/4” spacers.

 

[mcharfauros]

Small parts haul came in today. Rotors and pads for up front, studs for front hubs, along with hardware and gaskets. Power steering is get a full overhaul, New reservoir and hard lines to go with the rack and pinion I got a while ago.

 

[mcharfauros]

23May25

Still Nothing crazy going on with the 100 Series, tried my hand at removing the OE wood trim.

 

[mcharfauros]

Tiny project completed.

 

[mcharfauros]

Started out as a bearing, brake, and ball joint job. Ended up finding some BS.

Little bit of grease leaking out the passenger CV.

Found damaged dust seal, with the relief for the ABS sensor caved in.

End of the sensor damage. Gonna try and run it, since I wasn’t getting any lights on the dash prior to pulling it.

I found it odd the seal was missing a bolt, only to find it the head was sheared off. Gotta get it extracted.