Low steer arms for 25mm marlin trunnion kit ?

[darwink1]

Im looking to run marlins 25mm trunnion kit on my 87 fj60 axle under my 69 fj40. Problem is i cant run the histeer arms that come with the kit due to a lack of room (tie rod would make contact with the frame and pitman arm on uptravel). I also dont wanna fawk up the trac bar/drag link angles too much....

Btw the front is radius armed and coil sprung.

Someone suggested boring out the 60 arms so i could press in the marlin pin but im hesitant to to do so and would rather run a burly aftermarket arm.

Anyone know where i can find a set of either flat or stockish height arms that have a 1" bore for a removeable pin? Marlin only has histeer arms, have an email in to front range offroad but havent gotten a reply yet.

Best picture i have of my junk on hand but i can take more after work.

[URL=http://s818.photobucket.com/user/charlesk11charles/media/20141229_173030_zpsa3719726.jpg.html][/URL]

Thanks in advance.

D

 

[J Mack]

Luke @ www.4x4labs.com built mine for a reasonable price, I would give him a call.

 

[darwink1]

Yeah, now those look really nice!

D

 

[rusty_tlc]

I think the last page of this thread Chicago builds a 40 might help.

 

[darwink1]

Thank you very much sir.

D

 

[deliverance]

4x4 Labs here too

 

[White Stripe]

U could weld up the holes on the high steers, redrill them and put the taper on the other side of the arm rather than the top. Trail gear has reamers for 80 and 60 tre's