I recently got a carburetor in for rebuilding with a note from the customer saying that it had a flat spot after the last shop worked on it. Now those of us who've fussed with carbs for any amount of time know that there are many, many reasons...
Did not get as much done today as I wanted. Late start.
Drained fluids and pulled the interior out so far.
Damn this thing got dirty the last 3 years. I need to take better care of my work truck.
Rear door inner felts are the same for all years, so all good there.
Still need measurements for '74 and later front. I believe the pin distances are the same, so the specific measurements needed (in mm) are:
Overall length of the front inner...
I'm in the process of making reproduction inner window felts. Can someone help me to measure the length of the inner window felt for the following year ranges? Please measure in mm.
'73 and earlier
'74 and later
I have a couple of NOS samples...
Pete,
Pete is the painter. He's been around here for 30-40 years as a tech and painter. Great work. He uses a Sata for base and Iwata for clear. Not too bad for old school shop painting with a wet floor and no booth. Beats some of the best booth...
Spent the morning getting Blue Bird packed up and ready for home in Michigan.
I was about to pull the trigger on the City Racer EPS swap when I thought to message the stereo guy to get an appointment for Whitey and he had a cancellation this...
The parts soaked overnight in Zepp Purple full strength and all the goop came off nice and clean this morning
Front axle. Man. More flakey paint removal
Finally, cleaning the 3.70s I purchased for the project
Spent an hour this morning divesting myself of a couple of 60s I bought last year to part out. After dicking with one parts Cruiser and the cost of shipping and the hassle and the unreasonable jackasses I decided I’m out of the used parts...