Light Bar for a 40- The making (1 Viewer)

[ehsankiani]

Some pics of what we did yesterday..
Ehsan

 

[ehsankiani]

More........

 

[ehsankiani]

More......

 

[ehsankiani]

Installed

 

[ocdbeetle]

Looks like the prequel to a soft top safari rack.....

 

[ehsankiani]

Looks like the prequel to a soft top safari rack.....

Hmmm. Thats an idea. .

 

[Dieseler]

If you get front to back sway you can add a bracket and bolt it to the top corner of the windshield there is a hole there you can bolt to I had to do it for the safari rack I built.

 

[JohnnyC]

Looking good Ehsan

 

[ehsankiani]

Looking good Ehsan

Thank you
Ehsan

 

[sls019]

Light bar looks good. Let us see the rack when you finish.

 

[Cirbo]

I want to fabricate like you some day...

 

[Eshu Elegua]

nice,i like it...almost same that my friend fabricate for my roof rack.you can add the rack support just after the lights.will be great looking also

 

[ehsankiani]

nice,i like it...almost same that my friend fabricate for my roof rack.you can add the rack support just after the lights.will be great looking also

Nice setup.. Looks great.. What about the body attachment at the rear?
Ehsan

 

[johmbie]

Only cruiser people could look at a light bar and think "huh...I could extend that back and make a rack to carry that kitchen sink..." I love it!

 

[JohnnyC]

look what you can do

pics from Dieseler

https://forum.ih8mud.com/40-55-series-tech/40328-roof-racks-over-soft-top-2.html

https://forum.ih8mud.com/40-55-series-tech/247085-pakistani-rack-interest.html

 

[singletrackjunkie]

That rack looks nice, think how much better it would look with Ehsan's soft top

 

[ocdbeetle]

Nice setup.. Looks great.. What about the body attachment at the rear?
Ehsan

I'd think on the rear of the tub about where the reverse light would be.....SOR uses that area for locating theirs....Seems to be the best structural place....

I remember seeing a rack that busted loose when it was flexed(?)....It was attached at the rear to the bumper instead of the tub and flexed seperate from the front mount....

edit: Of course it could have just been poor welding.....?

 

[JohnnyC]

Ehsan you could always incorperate a tail light quard ( Specter Off-Road Land Cruiser Parts - Page 239 Light Guards ) into the design for rear bows of a rack support ?

 

[Eshu Elegua]

After debating here on many posts about roof racks over soft tops and the better way to support the legs.i ends on the simple way..a square plate with 4 screws.Reading here that the legs ending at the rear bumper will bend or make a crack on the welding My rig its not perfect at the rear corners,it does have a aluminum over the steel (PO ) and the fact that my rig its for trail use and not for mall shopping...

Sorry for bring again the roof rack topic over you post Eshan,but many member will looking for nice rack supports..take note on that..

 

[Eshu Elegua]

And just for fun more pic on the same trail..look the last picture and WHY i'll never buy a HeEp...jajjajaja ..sorry i can resist post the pic...