Hello all! This is my first time posting so let me know if I'm forgetting something. I have a gas '93 LC with 215,000 miles that blew a head gasket. When I pulled the head I found a tiny bit of scoring on the #6 cylinder. That coupled with leaking rear and front main seals convinced me to pull the engine and have it rebuilt. To make a long story short, the machine shop kept the engine for 3 months before completing work on it. I got it back last week and am almost finished putting it back together but I have 3 bolts that I can't identify left over. I labeled almost everything and laid it out in order of removal but 3 months is a long time! I'm almost ready to start it up but I hate to without knowing what these went to. The shorter (2") bolt was in a bag with the other bolt and nut that hold the power steering pump to the block, but I can't see anywhere this one could go. The other two (3") bolts were farther down the line (in order of removal) and I can't find anywhere they might go. The only other bolts that were anywhere near this long were two of the bolts that hold the top and bottom of the intake manifold together, but I have already installed those. Any help would be appreciated before I crank it up! Here is a pic of the bolts: