KNOBS (1 Viewer)

[kanzenbach]

the metal screw on the light switch has two holes in it do they make a tool for that And who refurbishes the knobs thx Buz

 

[Casey E]

More info needed. Is this a early light switch ? Or is this a latter model switch your talking about ? Most latter model are available new and the early models are reproduced by a few people on the forum. I wouldn’t pay to have it redone since the repo on early switches is so nice.

 

[Krondor]

The great @ToyotaMatt will solve all your problems.

 

[Engineer8000]

Pin nut wrench, @ToyotaMatt may have one. I just use needle nose pliers and a small crescent wrench.

 

[ToyotaMatt]

90' angle large snap ring pliers , use the death grip , then push in too like H#ll , then rotate lefty loosly ,

Tape off dash with blue painters tape all over near , if you wipe the nut out , not to worry i have all of then i reproduction status

but do not scratch your painted dash , Take time to site protect it like no tomorrow

NEW Early Modle Beveled Pin Wrench Nut / Bolt Pull Switch Retainer to Dash FJ40, FJ55 1964-12-78 - VintageTEqParts.com

QTY x 1 NEW Early Modle Beveled Aluminum Pin Wrench Nut Pull Switch Retainer Bolt to Dash This is a New...

vintageteqparts.com

Large NOS Pin Wrench Nut / BOLT Pull Switch Retainer to Dash FJ40, FJ55 90984-01003 - VintageTEqParts.com

NOS Aluminum Pin Wrench Nut Pull Switch Retainer Bolt to Dash This is a New OEM Toyota Genuine Part Fits ...

vintageteqparts.com

NEW Illuminated LARGE DIAMETER PULL STALK BOLT / Pin Wrench Nut / Pull Head Lamp Light Switch Retainer to Dash FJ40, FJ55 1973-10/85 USA Spec. and Beyond 90984-01005 headlight headlamp - VintageTEqParts.com

QTY x 1 NEW Illuminated LARGE DIAMETER PULL STALK Aluminum Pin Wrench Nut Pull Switch Retainer Bolt to Dash This...

vintageteqparts.com

Billet aluminum Small NOS Pin Wrench Nut / Bolt Pull Switch Retainer to Dash FJ40, FJ55, BJ42 - VintageTEqParts.com

Small Aluminum Pin Wrench Nut Pull Switch Retainer Bolt to Dash This is a TOP TIER SHELF in every way...

vintageteqparts.com

 

[Shark56]

As Matt said. I actually bought a cheap Harbor Junk set to use for just purpose. Set came with a 90⁰ that fit the holes almost perfectly.