First time replacing a flywheel or a clutch, I managed to get things done buy wedging a piece of wood with one hand while torquing with the other , and it was a huge pain.
Then when tightening my brand new from LC engineering bolts for the pressure place to 14ft/lbs, one broke off in the hole (bah!) , so now i get to take it all apart and start over from scratch. (I have reverse twist drill bits for removing the broken bolt)
I'm hoping for a method to keep the engine from turning when i tighten the bolts that leaves both hands free to torque the nuts.
Anyone one got recommendations, or better yet photos?
Thanks,
Cal-
Then when tightening my brand new from LC engineering bolts for the pressure place to 14ft/lbs, one broke off in the hole (bah!) , so now i get to take it all apart and start over from scratch. (I have reverse twist drill bits for removing the broken bolt)
I'm hoping for a method to keep the engine from turning when i tighten the bolts that leaves both hands free to torque the nuts.
Anyone one got recommendations, or better yet photos?
Thanks,
Cal-