My last to do was the turn signals. I don't really like the ARB turn signals, so I decided to make my marker lights the turn signals, like in a 100. I was about to order 100 marker housings when I realized I could DIY it.
On the left is the marker housing and the right is the fog/turn signal housing from the LX bumper. I couldn't find any other write ups but I'm sure someone else has done this. Seemed simple enough so I started cutting.
I measured and the turn signal and marker housings were almost identical except for the lightbulb mounting points. I cut the turn signal mounting/lock ring out of the fog/turn signal housing and cut off the marker light plug and enlarged the hole.
I filed everything down and cleaned it up a bit - not that it matters since no one will see this. Got the mounting surfaces smooth and bought some plastic epoxy.
A little messy but it's all weather sealed now. The epoxy was set after 20 minutes but I let it cure for 24 hours as it takes a little bit of force to get the O ring and lock to click into place on the turn signal.
Installed new bulbs (amber 7507)
Success. The epoxy is very strong once it's cured. And now the turn signal has a solid mount and the O ring is sealed just as it was in the bumper.
