How to install A/C in a 1st Gen Pickup/4Runner (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Yes, pulled from the low and high side r12 ports

Edit: So played around again with it for about 30 minutes. Swapped to a different fitting, seems to be holding pressure at the fitting. Looks like my leak is coming from the 2 manifold ports attached to the compressor so gives me a bit more confidence what to do next.
 
Last edited:
Add boost to your AC when temperatures get to 100°. Settings on recirculate by level Max AC. It's colder than it's ever been.

IMG_20250725_174953742_HDR.webp
 
AC is now blowing ice cold as of last night. Will be curious on my way home from work today how it does in 95F+ temps.

Ended up being the 4 o-rings on the bottom of the manifold ports on top of the compressor. OD was slightly smaller than the original R12 O-rings, not allowing it to make a complete seal when installed.
 

Users who are viewing this thread

Back
Top Bottom