Builds HDJ80 LHD #snlcbuilt Ute (pickup) (3 Viewers)

[Broski]

I already have the Diamond in an 8”, it was free.

I already have tcase gears.

Cheers

Free is good !!

So you are doing both sets ?

 

[cruisermatt]

really cool sheetmetal work. don't see that kind of stuff too much on 80's

 

[SNLC]

Free is good !!

So you are doing both sets ?

I have a HF2A with Sumo UD gears and part time. Tcase is already built and ready to go.

Cheers

 

[SNLC]

This just showed up, stoked!

Cheers

 

[SNLC]

Cheers

 

[ikarus]

View attachment 3434756View attachment 3434757

Cheers

Where did you get that? I need one!

 

[Broski]

View attachment 3434756View attachment 3434757

Cheers

It’s going to be RAD !!

 

[SNLC]

Where did you get that? I need one!

It is a 2016+ VDJ7x series, DPF (diesel particulate filter) hood. Front to rear dimensions are within 1”. Side to side the 80 is 3” wider. I will be grafting the 79 hood to the 80 hood.

Cheers

 

[SNLC]

RHS rockers during rebuild.

Cheers

 

[SNLC]

Getting the LHS cut apart and ready for rebuild.

Cheers

 

[SNLC]

Oh ya! All I need now for an engine rebuild is those bling conrods!

LHS inner rocker is in, it is a lot of work to rebuild rockers like this. Happy to be done with that soon.

Cheers

 

[SNLC]

Removed the skin from the 70-series DPF hood this afternoon.

We will be using some of the inner hood structure to do this as well.

Cheers

 

[mudgudgeon]

Oh ya! All I need now for an engine rebuild is those bling conrods!

View attachment 3436031

LHS inner rocker is in, it is a lot of work to rebuild rockers like this. Happy to be done with that soon.

View attachment 3436032
View attachment 3436033

Cheers

I still say, with all that work, its a missed opportunity to go RHS rocker and sliders.

Where you're at there is about the dance as what i did unstitching rockers on my 105 series. Then welded in rhs at the bottom pinch weld, where all the pillar structure met the RHS, and at the upper/inner rocker and door jambs.

Rock solid when done. Loads of ckearance under a low rig.
Not sure if I'd go to that much work again though.

 

[mudgudgeon]

Removed the skin from the 70-series DPF hood this afternoon.

View attachment 3436039
View attachment 3436040

We will be using some of the inner hood structure to do this as well.

View attachment 3436041

Cheers

Interested to see this done. Its a bit boxier than the 80s curves

 

[SNLC]

Cheers

 

[SNLC]

One more for today.

Cheers

 

[White Sheep]

That hood is going to be sweet. I wanted to do the same with my chopped 80 project. . .but first I need it to run.

 

[thatcabledude]

One more for today.

View attachment 3436881

Cheers

Impressive work for a shop that isn’t a custom paint and body shop.

 

[mudgudgeon]

Impressive work for a shop that isn’t a custom paint and body shop.

Cut twice, measure once . . .

 

[SNLC]

Interested to see this done. Its a bit boxier than the 80s curves

Cheers