Started to assemble the hardtop today. The bolt flange on the bottom of the sides does not stay in line with the tub. It's the same on both sides. It is fine at the back but, going forward it moves inward ending up 3/8 too far in at the front.
This is not a mated set from the factory. 74 tub and a 71 top. First thing I'll try is removing the rubber welting under the flange that SOR provides which is 1/8" thick and probably wasn't there originally.
Anyone else run into something like this?
This is not a mated set from the factory. 74 tub and a 71 top. First thing I'll try is removing the rubber welting under the flange that SOR provides which is 1/8" thick and probably wasn't there originally.
Anyone else run into something like this?