Front Hub Bolt size? (1 Viewer)

[NYIronPig]

Installing a set of warn locking hubs on my 74 -FJ40. Want to get some new bolts for the install. What is the correct size and are OEM still available before I start looking for stainless steel ones. Thx

 

[JackA]

Locking hubs? Wheel hubs? Brand of hub? Too many unanswered variables to give a response.

 

[NYIronPig]

Locking hubs? Wheel hubs? Brand of hub? Too many unanswered variables to give a response.

Sorry a set of warn locking hubs.

 

[peesalot]

No bolts, studs, cone washers, split washer, nut, & 2 shear pins per hub.
The hubs have countersunk holes , correct ?

 

[NYIronPig]

The 6 bolts needed to attach each locking hub is what I am looking for.

 

[B y r o n]

'74 and earlier use bolts to hold the locking hubs on, not studs/cone washers and nuts.

 

[meatloaf]

@cruiseroutfit should have everything you need

 

[Green Bean]

I believe that Cruiser Outfitters and Cruiser Brothers have what you need.

 

[Paul_A]

I would not use stainless--very weak. I would go grade 8 (hardened and tempered)--they don't rust like the softer ones do and they will take the torque. My .02.

 

[NYIronPig]

I would not use stainless--very weak. I would go grade 8 (hardened and tempered)--they don't rust like the softer ones do and they will take the torque. My .02.

Great what size then?

 

[locklaw]

Should be M8 best I can remember.

 

[Paul_A]

BTW, in addition to my previous post, check the length and use washers so as to not bottom out the bolt in the hole like I did and twist the heads off. Then I had to use an easy out to remove them. One of the simples jobs I could do became a night mare in a split second. Good luck.

 

[NYIronPig]

Should be M8 best I can remember.

do you know the correct length?