Replaced the busing last night. Took air chisel to the old metal bushing housing to get it out. I then cleaned the mount from the diff cover with wire brush and got the interior shiny again.
I pressed the new bushing in with grease and just the bolt and plate holding the bushing in. But cant seat it the last 3/16-1/4". What did you guys use to press this together? I'd prefer not to take the diff cover off to finish it...
I pressed the new bushing in with grease and just the bolt and plate holding the bushing in. But cant seat it the last 3/16-1/4". What did you guys use to press this together? I'd prefer not to take the diff cover off to finish it...