Just this week I installed an OME system in my 1987 FJ60, I also did this about 15+ years ago w/ another FJ60 and as I recall, I had the same drivers side lean that I have now.
Going deep in my memory banks and after a lot of trial and error from before, I recall installing a shim in a counter intuitive location to correct the lean. Yep - that was it, I installed a 3/8" x 4" metal plate sold by CCOT above the spring pack in the rear of the passenger side.
Just like 15+ years ago it worked like a champ this time again and took nearly an inch of lean down to about 1/8", I don't claim to understand the geometery, but it works it even contributed to improving the lean on the front also.
Hope this helps all those like me (OCD) that can not live with that lean.
Now to take care pesky rake- hopefully with some sand bags and a couple of months of driving it will level out a bit.
Thanks
Going deep in my memory banks and after a lot of trial and error from before, I recall installing a shim in a counter intuitive location to correct the lean. Yep - that was it, I installed a 3/8" x 4" metal plate sold by CCOT above the spring pack in the rear of the passenger side.
Just like 15+ years ago it worked like a champ this time again and took nearly an inch of lean down to about 1/8", I don't claim to understand the geometery, but it works it even contributed to improving the lean on the front also.
Hope this helps all those like me (OCD) that can not live with that lean.
Now to take care pesky rake- hopefully with some sand bags and a couple of months of driving it will level out a bit.
Thanks