Wanted Expo Ready Rig

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Whats your budget?
 
Yeah, I think you never stated all of your preferences, especially your budget, last time and people may have been concerned about wasting their time...
Obviously I have a truck like you describe, but it's not like I'm going to give it away (especially since I have no idea how to get anything I'd want more afterward!).
 
Seems like a fully built rigs are going for 20-35k currently. Paul Gardners rig was a great example and it sold for 25k and theres another built 100 on here for 35 I believe.
 
I should have put a little more detail in the original listing.

This should help. As for price Im looking for a nice well sorta cruiser and
am willing to spend 20-35K for the right rig.

Here is a list of what I’m trying to find:

Well maintained and clean rig ideally with most of the following mods:

-Front bumper with Winch
-Rear Slee Dual Swingout with Jerry Can Holder and Ladder
-OME 2.5” Lift
-Slee Diff Drop Kit
-Sliders
-Dual Batteries
-Roof Rack
-ARB air compressor
-Blue Sea Controller
-Drawer system
-CB system
-Upgraded Suspension with UCA's ...ICONs would be nice
-ARB fridge

This is a rough guide and would like to hear about any similar setup.

Oakmont
 
Oak - my '99 has all that and a bit more. PM me if you want to talk. I have an '08 that I am slowly building up to replace it, haven't gotten the 08 done hence the 99 is still in the stable.
 
I sold this one for $35k.

The Millennium Mall Crawler

For Sale - 2000 UZJ100 heavily built to the max for Overlanding

Baja 18.jpg

Baja 17.jpg

done.jpg


The buyer had a low mile UZJ100 in the shop and wanted to go the same route I did on his build. He pulled his truck from the shop, sold it and bought mine.

I could easily build you a UZJ100 like that, I have built a number of Cruisers for overlanding and have done three drives to Panama and back. If you can't find what you want feel free contact me to discuss a build. I can also help located the base truck to start with.


Cheers
 
RMP,

I will definitely keep that in mind. I hope to find a completed project, but
we'll see how it plays out. Great looking cruiser.

Oakmont
 
I've got a 2000 that's got most of what you're looking for. My wife and I used it for full-time travel the past year and a half. I haven't posted it for sale anywhere, but we've transitioned back to normal life and I'm considering letting it go for the right price.
Build thread here: 100 Series Land Cruiser - Northbound and Down
 
I've got a 2000 that's got most of what you're looking for. My wife and I used it for full-time travel the past year and a half. I haven't posted it for sale anywhere, but we've transitioned back to normal life and I'm considering letting it go for the right price.
Build thread here: 100 Series Land Cruiser - Northbound and Down

Awesome build
 
Krice,

That is a nice rig. If I wasn't so crazy about the 100 series I would definitely give it a hard look.

Oakmont
 
I will sell mine. Only time i went offroading with it is HiH7. I found a 200. Priced less than your starting budget

2017-07-23 08.55.04.jpg


20170321_102236 (1).jpg


20170724_075721.jpg
 
Last edited:
Going to let mine go for a 200 Maltec build this winter. I bought from ih8mud member with 177k, it's at 188k now after 8 mo or so.. Not a daily driver, purely a travel rig. email me schimsk@gmail.com

DSC_0008.JPG


DSC_0020.JPG


DSC_0067.JPG


DSC_0102.JPG


DSC_0486.JPG
 
Am I the only person who doesn't consider a truck 'fully built' unless it has correct gearing and locked front&rear ?? Seems to me thats the most important part if your actually going to go offroad. If its not geared correctly and locked, then good luck putting any of that armor to use at all without getting completely stuck. Atrac breaks axles, I've seen it. ATRAC in no way whatsoever replaces a true locker. My buddy who is a very conservative driver had ATRAC snap his front CV on a slippery little mud patch. Thats my rant for today, carry on.
 

Users who are viewing this thread

Back
Top Bottom